Your Watch Collection
Show us what you are wearing today, or any watch in your collection - or even show off your whole watch collection. What watches have you purchased recently? :)
986 topics in this forum
-
- 4.2k replies
- 714.3k views
-
- 1.4k replies
- 200.3k views
-
- 1.1k replies
- 117.9k views
-
- 1 reply
- 43k views
-
- 80 replies
- 27.2k views
-
- 113 replies
- 27k views
-
- 42 replies
- 23.8k views
-
- 41 replies
- 21k views
-
- 65 replies
- 20.5k views
-
- 32 replies
- 19.6k views
-
- 25 replies
- 17.8k views
-
- 10 replies
- 15.7k views
-
- 7 replies
- 15.2k views
-
- 8 replies
- 14.7k views
-
- 8 replies
- 14.6k views
-
- 4 replies
- 14.6k views
-
- 28 replies
- 14.1k views
-
- 3 replies
- 13.5k views
-
- 6 replies
- 13.3k views
-
- 4 replies
- 13.3k views
-
- 16 replies
- 13.2k views
-
- 4 replies
- 12.7k views
-
- 10 replies
- 12.1k views
-
- 5 replies
- 12k views
-
- 14 replies
- 11.8k views
-
Topics
-
-
Posts
-
Any other thoughts on how I can get a replacement coil? Any “hidden” or unknown physical shops (in Australia or elsewhere) that might have them in stock (but not always online)? -
I discovered this last night when I printed my model, I'll try and tweak the design a little and re-post here -
That could work - two blunt pressure points would spread out the force required in order to reduce damage, and two small pins should fit slightly angled through the inner coil of the spring. I was thinking about this while working on other chores and had a crazy thought when I saw a can of expanding rigid sprayable foam, but who'd want to have to clean out the barrel and spring after that? -
That's very observant of you, Nev & that the 4th wheel is from another movement & has been dished to fit does seem a more likely explanation. Thanks for the education re calculating the rate & spring frequency. In the meantime, spurred by your earlier comnent, I risked a further tinker with the balance spring, cleaning it, fully un-kinking the last few cms (I'd been worried about breaking it first time round) & pinning it at the very end. The clock now seems to be running slow when the regulator is in that position so some progress at last.....Many thanks, once again! -
By rjenkinsgb · Posted
Snap! I recently finished my Gruen 510 movement - though the case for mine is in a rather sad state; I'm going to try re-plating it (in nickel, it's not a gold one). Re. the screws, I got a few of the one gram mixed batches from ebay. I've only needed a couple of screws for things so far, both rare, minuscule types - but both in the mix, after enough time sorting through them! The ones such as normal bridge screws are quite common in those lots.
-
