Introduce Yourself Here
New to the community? We like to know who we are chatting with :)
So why not introduce yourself here first!
4194 topics in this forum
-
- 12 replies
- 2.3k views
-
- 14 replies
- 3.3k views
-
- 19 replies
- 3.8k views
-
- 18 replies
- 2.7k views
-
- 9 replies
- 1.4k views
-
- 16 replies
- 2.5k views
-
- 10 replies
- 1.7k views
-
- 8 replies
- 1.7k views
-
- 6 replies
- 2.2k views
-
- 6 replies
- 1.2k views
-
- 6 replies
- 1.3k views
-
- 6 replies
- 1.2k views
-
- 4 replies
- 1k views
-
- 7 replies
- 1.7k views
-
- 17 replies
- 1.9k views
-
- 12 replies
- 2.4k views
-
- 9 replies
- 2.1k views
-
- 9 replies
- 1.5k views
-
- 8 replies
- 1.7k views
-
- 5 replies
- 1.1k views
-
- 3 replies
- 947 views
-
- 5 replies
- 1.1k views
-
- 6 replies
- 1.2k views
-
- 16 replies
- 3.1k views
-
- 8 replies
- 1.4k views
-
Topics
-
-
Posts
-
Maybe you should make friends with someone who has a 3D printer -
By Michael1962 · Posted
If the front of the case has no bezel and has an internal diameter less than the outside diameter of the lock ring, there is only one way that the crystal comes out and that is from the back. You could always smash it and take it out the front. I’m here to help. 😉 Take a photo of the crystal side of the case. -
I have no idea ? I'm new to this. But, there is definitely a locking ring at the rear of the crystal and no detachable bezel on the front of case ? So, I am guessing you need to back off that ring ? There must be someone on the forum that has restored one of these ? -
-
-
