Your Current Projects and Achievements
If you would like to discuss your current projects or show off your latest watch repair achievement and it is not an actual walkthrough please post here.
SECTION RULES
This section if for posting the results of your labours with a particular project. If you wish to post a full walkthrough then please use this section.
536 topics in this forum
-
- 14 replies
- 3.2k views
-
- 15 replies
- 4.6k views
-
- 8 replies
- 4.3k views
-
- 12 replies
- 2.3k views
-
- 8 replies
- 3k views
-
- 12 replies
- 3k views
-
- 2 replies
- 3.2k views
-
- 0 replies
- 1.8k views
-
- 0 replies
- 1.8k views
-
- 5 replies
- 1.8k views
-
- 2 replies
- 1.1k views
-
- 1 reply
- 1.3k views
-
- 5 replies
- 2.9k views
-
- 1 reply
- 2k views
-
- 5 replies
- 3.3k views
-
- 1 reply
- 1.3k views
-
- 0 replies
- 1.4k views
-
- 1 reply
- 2.4k views
-
- 2 replies
- 2k views
-
- 39 replies
- 9.2k views
-
- 1 reply
- 9.5k views
-
- 2 replies
- 2.8k views
-
- 1 reply
- 1.4k views
-
- 20 replies
- 6.2k views
-
- 2 replies
- 3.8k views
-
Topics
-
-
Posts
-
By HorologyHead · Posted
RichardHarris123: Hello and welcome from Leeds, England. I have family all over Australia, went as £10 poms Thanks Richard. Hope you’re able to visit your family here and that they’ve all done well 🙂 My relatives arrived from England in the 1790s transported on the ‘Second & Third Fleets’—a story of timber sailing ships, of convicts and doing well in this huge Country of Australia. When I visited the UK in the 1980s, I was too young to comprehend the depth and breadth of its history… Best wishes, Mike William Chapman, my 4th great Grandad’s charges, at age 23 read at the Old Bailey; sentenced to 7 years of transportation to Sydney. -
The whole process and the progress are closely observed, it's hand-driven and very controlled. I can't see the "danger", unless you are watching the TV while doing it. As you could have read, and in this quote "wheel" is the balance-wheel. -
Have you got the pallet fork installed in the movement when you see the train move when using the setting works? As nevenbekriev said, without the pallet fork to lock the train, the behaviour you are describing is normal. If this is happening with the pallet fork installed, you have a problem in the gear train, it should be immobile when the pallet fork is locking the escape wheel. The fit of the circlip above the pinions on that wheel is crooked in your pictures, it should sit flat up against the upper pinion as in Marc’s picture. Hope that helps, Mark -
Hi I got a Jaeger LeCoultre K911 movement, where one of the stems was broken. Part no. Should be 401. Im based in Europe and tried Cousins but its discontinued. They except to get stem in stock for cal. K916 but will that work? Or Is there a way out to join the ends? -
The part was how it fell out of the movement - the train wheel bridge wasn’t screwed in. I’ll probably dismantle the part, if I can, to work it out. The train of wheels ran fine - it was only once the keyless works were installed I noticed the problem.
-
