Your Current Projects and Achievements
If you would like to discuss your current projects or show off your latest watch repair achievement and it is not an actual walkthrough please post here.
SECTION RULES
This section if for posting the results of your labours with a particular project. If you wish to post a full walkthrough then please use this section.
409 topics in this forum
-
- 0 replies
- 871 views
-
- 5 replies
- 2.4k views
-
- 5 replies
- 2.4k views
-
- 8 replies
- 2.8k views
-
- 6 replies
- 1.3k views
-
- 2 replies
- 1.4k views
-
- 16 replies
- 2.6k views
-
- 13 replies
- 2.1k views
-
- 13 replies
- 2.1k views
-
- 0 replies
- 1.5k views
-
- 0 replies
- 1.1k views
-
- 1 reply
- 1.4k views
-
- 5 replies
- 1.5k views
-
- 9 replies
- 3.4k views
-
- 6 replies
- 1.5k views
-
- 5 replies
- 3.5k views
-
- 15 replies
- 3.3k views
-
- 4 replies
- 1.4k views
-
- 0 replies
- 2.3k views
-
- 2 replies
- 1.4k views
-
- 0 replies
- 1.1k views
-
- 7 replies
- 2.7k views
-
- 6 replies
- 2.8k views
-
- 5 replies
- 1.4k views
-
- 6 replies
- 2k views
-
Topics
-
-
Posts
-
I will try and get some pictures of the pallet fork in the watch. I assume you want the balance removed though? I also assume you want to see the lock on the stones? I did nothing other than take the balance in and out. With no power on the watch, if I manually rotate the balance like you say, it will rotate back and forth, the pallet fork is doing it's thing and the pallet wheel is turning... it does down in about 5 - 7 seconds I would say. -
I did something better yet, I updated my report and included a link to this thread! 😎 -
Tradera doesn't swich pics to show the movement, I guess its a ST96. Made in India. -
By Neverenoughwatches · Posted
Haha, i used to do that when i spotted fake rolexes partly hidden in the corners of joblot watches. I guess the seller would hope some poor soul would think he had discovered a hidden gem and bid up. I suggested i was part of rolex's elite fraud squad and would be visiting the address listed by the end of the day, the listing promptly disappeared 🤣 -
Hairspring coil is not concentric " pushed to side" , hairspring needs a bit of manipulation near the stud to center the coil. Turn the stud with a reglare screw driver to center the coil, thats all it needs.
-
