Watch or Horology Related Videos
Post an interesting watch or horology related video here. Please write a small synopsis or description of why you think the video is interesting. If the video was made by you please say so.
SECTION RULES
- You must have a minimum of 10 posts in order to contribute in this section.
- Videos must be in keeping with the theme of this forum, Watches & Horology - repairs or restorations.
-
Practical demonstrations of associated techniques used in watch repair are allowed.
For example: Machining, Metal Work, Engraving, Watch Manufacturing, Component Engineering, etc. - Videos with only commercial sales content should not be posted here.
- If you are a YouTuber and you make regular watch repair tutorials or demonstrations then you can post here, but please make it clear that you are the creator.
151 topics in this forum
-
- 2 replies
- 2.4k views
-
- 2 replies
- 3.9k views
-
- 2 replies
- 1.3k views
-
- 2 replies
- 1.6k views
-
- 2 replies
- 2.3k views
-
- 2 replies
- 2.7k views
-
- 2 replies
- 3k views
-
- 2 replies
- 2.9k views
-
- 2 replies
- 1.8k views
-
- 2 replies
- 441 views
-
- 1 reply
- 4.6k views
-
- 1 reply
- 1.7k views
-
- 1 reply
- 4.2k views
-
- 1 reply
- 2.7k views
-
- 1 reply
- 1.9k views
-
- 1 reply
- 1.6k views
-
- 1 reply
- 1.4k views
-
- 1 reply
- 3.6k views
-
- 1 reply
- 2.5k views
-
- 1 reply
- 2.3k views
-
- 1 reply
- 1.8k views
-
- 1 reply
- 2.5k views
-
- 1 reply
- 1.6k views
-
- 1 reply
- 1.3k views
-
- 1 reply
- 1.3k views
.thumb.jpg.cb17a66989f1e796fd4217db2e9ca9df.jpg)
-
Topics
-
-
Posts
-
By rjenkinsgb · Posted
You could get one 3D printed in stainless or titanium? Add the rest of the original detail to your existing model and proof check it comes out OK in plastic, then have it done by JLC, Shapeways etc. Not cheap, but you could get a lot closer the original appearance? -
By LittleWatchShop · Posted
Back to lathes...I think you need the sherline mill and a ww lathe. I bought my sherline lathe simply to hold larger work pieces than a WW lathe. So far I have usedbit for making tools and not watch or clock parts. Done very little with the mill, but did experiment with making opinions. Lile yourself, I am a novice that does not shrink from trying the impossible...up to a point. There is a guy on NAWCC forum, Jerry Kieffer who is the master of the Sherline for horologi al work. -
By rjenkinsgb · Posted
Again, EDTA solution as I mentioned above, or Evaporust. They attack oxides but not good metal. After some hours, all the rust should have gone. -
Hi How can I clean this watch case rubber ring? It got the melted gasket on it... -
By Sebastiaan · Posted
Thank you for the reading material
-
