Watch or Horology Related Videos
Post an interesting watch or horology related video here. Please write a small synopsis or description of why you think the video is interesting. If the video was made by you please say so.
SECTION RULES
- You must have a minimum of 10 posts in order to contribute in this section.
- Videos must be in keeping with the theme of this forum, Watches & Horology - repairs or restorations.
-
Practical demonstrations of associated techniques used in watch repair are allowed.
For example: Machining, Metal Work, Engraving, Watch Manufacturing, Component Engineering, etc. - Videos with only commercial sales content should not be posted here.
- If you are a YouTuber and you make regular watch repair tutorials or demonstrations then you can post here, but please make it clear that you are the creator.
151 topics in this forum
-
- 4 replies
- 3.5k views
-
- 4 replies
- 7k views
-
- 4 replies
- 2.3k views
-
- 4 replies
- 1.9k views
-
- 4 replies
- 2k views
-
- 4 replies
- 3.7k views
-
- 4 replies
- 1.8k views
-
- 3 replies
- 8.9k views
-
- 3 replies
- 5.5k views
-
- 3 replies
- 2k views
-
- 3 replies
- 2.3k views
-
- 3 replies
- 3.3k views
-
- 3 replies
- 2.5k views
-
- 3 replies
- 2.9k views
-
- 3 replies
- 1.6k views
-
- 3 replies
- 2.1k views
-
- 3 replies
- 1.7k views
-
- 3 replies
- 2.3k views
-
- 3 replies
- 3.3k views
-
- 3 replies
- 1.8k views
-
- 3 replies
- 1.2k views
-
- 2 replies
- 6.2k views
-
- 2 replies
- 3.2k views
-
- 2 replies
- 1.7k views
-
- 2 replies
- 2k views
-
Topics
-
-
Posts
-
By rjenkinsgb · Posted
Again, EDTA solution as I mentioned above, or Evaporust. They attack oxides but not good metal. After some hours, all the rust should have gone. -
Hi How can I clean this watch case rubber ring? It got the melted gasket on it... -
By Sebastiaan · Posted
Thank you for the reading material -
By watchweasol · Posted
Hi one assumes by the addition of the pictures you have the technical sheet for this watch. As mentioned by @HectorLooi center wheel canon pinion .take it down again and install only the parts required to set the hacking and turn the hands checking at each stage for correct operation. -
By watchweasol · Posted
Hi if it is a Swiss made watch badged by ingersoll (eubauches) ther is likely a makers mark and number under the balance that may help . If you open it up and post a picture of the movement plus Any numbers.
-
