Jump to content
jdrichard

Making a Jewel Setting on a Boley Lathe

Recommended Posts

I have attached a video i made where i have made a lower balance jewel setting for a full plate Waltham pocket watch. I made one and cut it too low so the second one i made was not cut as deep. I made the jewel flush so it could be held in place by the cap jewel. Worked great. Will need to make a graver to cut at a right angle to the setting face.

 

 

 

Sent from my iPhone using Tapatalk Pro

Share this post


Link to post
Share on other sites

I have attached a video i made where i have made a lower balance jewel setting for a full plate Waltham pocket watch. I made one and cut it too low so the second one i made was not cut as deep. I made the jewel flush so it could be held in place by the cap jewel. Worked great. Will need to make a graver to cut at a right angle to the setting face.
 

 
 
Sent from my iPhone using Tapatalk Pro


4d4c2ef6d42d0e41c70745417ecfc29b.jpgc24a4b07c11d15f9d1e8bd4de6423731.jpg



Sent from my iPhone using Tapatalk Pro

Share this post


Link to post
Share on other sites

×