Your Watch Collection
Show us what you are wearing today, or any watch in your collection - or even show off your whole watch collection. What watches have you purchased recently? :)
989 topics in this forum
-
- 2 replies
- 1.9k views
-
- 8 replies
- 2.1k views
-
- 4 replies
- 4.8k views
-
- 6 replies
- 3.9k views
-
- 1 reply
- 3.5k views
-
- 2 replies
- 5.7k views
-
- 14 replies
- 3.1k views
-
- 5 replies
- 4k views
-
- 5 replies
- 2.3k views
-
- 3 replies
- 1.6k views
-
- 2 replies
- 3.8k views
-
- 1 reply
- 1k views
-
- 5 replies
- 2.4k views
-
- 4 replies
- 2.2k views
-
- 21 replies
- 8.6k views
-
- 6 replies
- 2.8k views
-
- 4 replies
- 1.8k views
-
- 7 replies
- 5.6k views
-
- 26 replies
- 8.4k views
-
- 2 replies
- 1.4k views
-
- 14 replies
- 3k views
-
- 33 replies
- 7.4k views
-
- 5 replies
- 1.6k views
-
- 3 replies
- 4.7k views
-
- 1 reply
- 3.8k views
.thumb.jpg.393f37c5e514c65f88ea5d88f5e5e399.jpg)
-
Topics
-
-
Posts
-
[Myota2034] Custom simple quartz watch — PricewaterhouseCoopers On a very very different note, here is a watch from approximately 2000 when I was a Partner with PwC, Management Consulting. It was a simple “marketing watch” with a clever “vase of knowledge” that is subtly revealed on the dial as the second hand progresses. Clever for a simple watch!⌚️ -
By Neverenoughwatches · Posted
I think someone else has though. Some where here using a modified perspex sheet. I may be wrong i may be right , i think it involved fitting the arbor to a pin vice. I dont have experience of the bergeon winders, are the handles not interchangeable ? -
By Neverenoughwatches · Posted
Never tried dial dots, i always considered them as a bit of a bodge. You are adding something that was never intended to be there. I wonder how the adhesive reacts to any part of the movement, hot summer heat and i think things might turn sticky. Most adhesive backed stuff has a tendency to soften and slide around so it may spread, i have used a lot of so called sticks all adhesives in my industry that are just not up to the job. I suppose they get you out of a problem quickly, but how permanently might that be ? I would just explain to the owner that it may or may not work. WWs other ideas are a much more permanent solution but both have their risks . I've tried milling and dial feet replacements, hmm it was ok, ive heard of folk dimpling the face , so that needs care . And i have soldered a few times , all with good results but i am very careful and I practiced it a lot. -
Thanks very much watchweasol. A couple more dummy questions. What do you mean by 'cut block'? and to see if there is pulse on the chip, which contacts on the chip should I connect the multimeter? Many thanks -
It’s definitely a field that is not understood but is probably now the most important in manufacturing with the huge amount of automation and robotics being applied. Tom
-
