Your Walkthroughs and Techniques
Post descriptive walkthroughs of watches you have stripped down and serviced and/or repaired, parts you have made or techniques you wish to share.
This is an interesting section where we post our challenges and how we have over-come them. You can also post walkthroughs and share your techniques.
SECTION RULES
This section is strictly for those posting real step-by-step walkthroughs of actual repair or servicing techniques relating to watch repair and/or horology in general. The idea is that we help each other by describing or sharing our repair techniques, or telling a story of how we have progressed.
If you are not posting step-by-step walkthroughs, such as - you would just like to showcase a completed repair job, then please choose a more appropriate sub-forum for your content. If your post is not deemed to be a legitimate walkthrough then a moderator will move your post to the appropriate section without notice. Thank you for your co-operation.
- You must be a member with at least 10 posts on the forum in order to contribute in this section
380 topics in this forum
-
- 5 replies
- 5.9k views
-
- 5 replies
- 5.3k views
-
- 5 replies
- 5.4k views
-
- 5 replies
- 10.1k views
-
- 5 replies
- 4.2k views
-
- 5 replies
- 2.5k views
-
- 5 replies
- 524 views
-
- 4 replies
- 5.5k views
-
- 4 replies
- 9.5k views
-
- 4 replies
- 4.1k views
-
- 4 replies
- 6.1k views
-
- 4 replies
- 13.3k views
-
- 4 replies
- 13.3k views
-
- 4 replies
- 8.5k views
-
- 4 replies
- 4.2k views
-
- 4 replies
- 9.2k views
-
- 4 replies
- 10.5k views
-
- 4 replies
- 4.8k views
-
- 4 replies
- 7.1k views
-
- 4 replies
- 10.3k views
-
- 4 replies
- 4.2k views
-
- 4 replies
- 8.8k views
-
- 4 replies
- 5.5k views
-
- 4 replies
- 4.9k views
-
- 4 replies
- 8.7k views
-
Topics
-
-
Posts
-
Hi,what is the model number for that case? Is possible I have one for service with me,if so then I can measure for you the factory size of the bezel -
By RichardHarris123 · Posted
My hair went in my early twenties, shaved it off and never looked back. -
It can be a good idea to replace the gasket as well, especially if has any kind of damage. If it's a very tight fit between the gasket and the crystal, a thin layer of silicon grease on the gasket can help a lot. Keep us updated! -
Double checked, definitely a fake bezel. It has a thin plastic gasket that creates the seal for the crystal. I went ahead and gave the case a good cleaning, and light polish. Now Im just hoping I can install the new crystal with out screwing up! I will likely be putting it in tomorrow night. -
Try the gel we used during covid. Works really great for removing gasket-turned-to-tar residue.
-
