Watch Parts, Sourcing Parts, Movements, Materials and Lubrication Products
Discussing watch parts, the sourcing of watch parts and movements, and products required to repair and service watch movements
566 topics in this forum
-
- 127 replies
- 40.6k views
-
- 101 replies
- 36.4k views
-
- 63 replies
- 5.7k views
-
- 52 replies
- 7.5k views
-
- 45 replies
- 7.4k views
-
- 41 replies
- 8.5k views
-
- 40 replies
- 6.9k views
-
- 38 replies
- 3.7k views
-
- 36 replies
- 2.9k views
-
- 34 replies
- 13.8k views
-
- 34 replies
- 6.6k views
-
- 32 replies
- 4.6k views
-
- 31 replies
- 6.6k views
-
- 31 replies
- 2k views
-
- 29 replies
- 6.3k views
-
- 29 replies
- 4.9k views
-
- 28 replies
- 6.4k views
-
- 28 replies
- 5.8k views
-
- 28 replies
- 3.9k views
-
- 28 replies
- 2.3k views
-
- 27 replies
- 3.1k views
-
- 27 replies
- 1.1k views
-
- 24 replies
- 4.5k views
-
- 24 replies
- 4.4k views
-
- 23 replies
- 4.2k views
-
Topics
-
-
Posts
-
-
-
-
By coreymsnow · Posted
Hah! Well, California will have to do. Lived in TX for a brief period back in the early 70s, though, so maybe that counts. 🙂 Funny you should mention making vacuum tubes- I've actually tinkered with that! It's REALLY tough to do, and I've never made one more complicated than a simple diode that barely worked, but I have played around at it. But there's just no infrastructure for vacuum tube fabrication. I can get a lathe and learn how to use it to make complex parts, and while it might take a while to learn- and money to get the equipment, of course- it is possible to do more or less "off the shelf". But vacuum tubes, not so much. There are a few folks out there doing some crazy cool work with bespoke tubes, but they have setups that are far beyond what I can manage in my environment and it's mostly stuff they built by hand. I also have been playing with making piezoelectric Rochelle Salt crystals to replace ancient vacuum tube turntable needles- nobody's made those commercially for probably 60 years. I'm a sucker for learning how to do weird things no one does any more so I can make things no one uses work again. (I think this is drifting off the topic of lathes, lol). -
By LittleWatchShop · Posted
You shoulda been born in Texas. Tough to make a vacuum tube though. You can substitute with a MOSFET eq ckt I guess. I was playing around making a pinion the other day. More to it than meets the eye.
-
