Shock Settings - Incablock, Diashock - Fitting/Adjusting Jewels, etc..
Discussing shock settings such as Incabloc and Diashock etc..
Fitting and the adjustment of Jeweled Bearings, Pallet Stones, Impulse Jewels
82 topics in this forum
-
- 43 replies
- 3.4k views
-
- 40 replies
- 6.6k views
-
- 33 replies
- 4.5k views
-
- 28 replies
- 2.8k views
-
- 26 replies
- 2.9k views
-
- 24 replies
- 1.3k views
-
- 23 replies
- 1.3k views
-
- 21 replies
- 844 views
-
- 20 replies
- 2k views
-
- 19 replies
- 1.1k views
-
- 18 replies
- 2.5k views
-
- 18 replies
- 1.1k views
-
- 17 replies
- 2.1k views
-
- 17 replies
- 1.8k views
-
- 15 replies
- 2.4k views
-
- 15 replies
- 3.3k views
-
- 14 replies
- 1k views
-
- 13 replies
- 2.1k views
-
- 12 replies
- 800 views
-
- 12 replies
- 1.3k views
-
- 12 replies
- 3k views
-
- 12 replies
- 5.3k views
-
- 12 replies
- 2.5k views
-
- 11 replies
- 410 views
-
- 10 replies
- 1.6k views
-
Topics
-
-
Posts
-
That could work - two blunt pressure points would spread out the force required in order to reduce damage, and two small pins should fit slightly angled through the inner coil of the spring. I was thinking about this while working on other chores and had a crazy thought when I saw a can of expanding rigid sprayable foam, but who'd want to have to clean out the barrel and spring after that? -
That's very observant of you, Nev & that the 4th wheel is from another movement & has been dished to fit does seem a more likely explanation. Thanks for the education re calculating the rate & spring frequency. In the meantime, spurred by your earlier comnent, I risked a further tinker with the balance spring, cleaning it, fully un-kinking the last few cms (I'd been worried about breaking it first time round) & pinning it at the very end. The clock now seems to be running slow when the regulator is in that position so some progress at last.....Many thanks, once again! -
By rjenkinsgb · Posted
Snap! I recently finished my Gruen 510 movement - though the case for mine is in a rather sad state; I'm going to try re-plating it (in nickel, it's not a gold one). Re. the screws, I got a few of the one gram mixed batches from ebay. I've only needed a couple of screws for things so far, both rare, minuscule types - but both in the mix, after enough time sorting through them! The ones such as normal bridge screws are quite common in those lots. -
By rjenkinsgb · Posted
Two pins or screwdrivers angled out slightly, pressing through from the barrel centre from the opposite side so they contact just clear of the hole in the lid? eg. Strap pin driver needles or similar. -
That's a good idea - shrinking down the nut and wrench size from the old casebook trick!
-
