Lathes for Watchmakers / Mini Lathes & Jacot tools and all related
Discussions on Watchmakers or Mini Lathes and associated Accessories as well as Jacot tools and their accessories
187 topics in this forum
-
- 22 replies
- 4.8k views
-
- 3 replies
- 3.4k views
-
- 3 replies
- 3k views
-
- 3 replies
- 2.9k views
-
- 7 replies
- 3.4k views
-
- 17 replies
- 10k views
-
- 2 replies
- 2.6k views
-
- 12 replies
- 3.4k views
-
- 9 replies
- 8k views
-
- 18 replies
- 5.6k views
-
- 2 replies
- 4.1k views
-
- 9 replies
- 3.7k views
-
- 17 replies
- 5.9k views
-
- 1 reply
- 2.1k views
-
- 2 replies
- 2k views
-
- 28 replies
- 7.4k views
-
- 9 replies
- 3.2k views
-
- 24 replies
- 4.8k views
-
- 3 replies
- 3k views
-
- 1 reply
- 5.7k views
-
- 5 replies
- 2.7k views
-
- 7 replies
- 8.3k views
-
- 7 replies
- 2.8k views
-
- 1 reply
- 3.5k views
-
- 51 replies
- 15.7k views
-
Topics
-
-
Posts
-
Hi,what is the model number for that case? Is possible I have one for service with me,if so then I can measure for you the factory size of the bezel -
By RichardHarris123 · Posted
My hair went in my early twenties, shaved it off and never looked back. -
It can be a good idea to replace the gasket as well, especially if has any kind of damage. If it's a very tight fit between the gasket and the crystal, a thin layer of silicon grease on the gasket can help a lot. Keep us updated! -
Double checked, definitely a fake bezel. It has a thin plastic gasket that creates the seal for the crystal. I went ahead and gave the case a good cleaning, and light polish. Now Im just hoping I can install the new crystal with out screwing up! I will likely be putting it in tomorrow night. -
Try the gel we used during covid. Works really great for removing gasket-turned-to-tar residue.
-
