Mainspring and Winding Tools
Discussions on winding mainsprings back into the Going Barrel.
61 topics in this forum
-
- 6 replies
- 3.8k views
-
- 6 replies
- 3.3k views
-
- 5 replies
- 3.3k views
-
- 5 replies
- 2.7k views
-
- 5 replies
- 2.6k views
-
- 5 replies
- 2.1k views
-
- 5 replies
- 6.6k views
-
- 4 replies
- 1.4k views
-
- 4 replies
- 312 views
-
- 4 replies
- 7.7k views
-
- 4 replies
- 6.8k views
-
- 4 replies
- 2.8k views
-
- 4 replies
- 8.4k views
-
- 4 replies
- 4.8k views
-
- 3 replies
- 2.2k views
-
- 3 replies
- 882 views
-
- 3 replies
- 1.8k views
-
- 3 replies
- 1.7k views
-
- 2 replies
- 1.1k views
-
- 2 replies
- 2.2k views
-
- 2 replies
- 2.5k views
-
- 2 replies
- 521 views
-
- 2 replies
- 4.5k views
-
- 2 replies
- 4.3k views
-
- 2 replies
- 2.2k views
-
Topics
-
-
Posts
-
Hi,what is the model number for that case? Is possible I have one for service with me,if so then I can measure for you the factory size of the bezel -
By RichardHarris123 · Posted
My hair went in my early twenties, shaved it off and never looked back. -
It can be a good idea to replace the gasket as well, especially if has any kind of damage. If it's a very tight fit between the gasket and the crystal, a thin layer of silicon grease on the gasket can help a lot. Keep us updated! -
Double checked, definitely a fake bezel. It has a thin plastic gasket that creates the seal for the crystal. I went ahead and gave the case a good cleaning, and light polish. Now Im just hoping I can install the new crystal with out screwing up! I will likely be putting it in tomorrow night. -
Try the gel we used during covid. Works really great for removing gasket-turned-to-tar residue.
-
