Introduce Yourself Here
New to the community? We like to know who we are chatting with :)
So why not introduce yourself here first!
4174 topics in this forum
-
- 2 replies
- 1k views
-
- 2 replies
- 955 views
-
- 2 replies
- 1.1k views
-
- 2 replies
- 809 views
-
- 2 replies
- 1.1k views
-
- 2 replies
- 3.7k views
-
- 2 replies
- 1.3k views
-
- 2 replies
- 1.8k views
-
- 2 replies
- 1.2k views
-
- 2 replies
- 1.3k views
-
- 2 replies
- 1.3k views
-
- 2 replies
- 1.7k views
-
- 2 replies
- 962 views
-
- 2 replies
- 2.1k views
-
- 2 replies
- 892 views
-
- 2 replies
- 1.6k views
-
- 2 replies
- 1.3k views
-
- 2 replies
- 741 views
-
- 2 replies
- 882 views
-
- 2 replies
- 1.3k views
-
- 2 replies
- 1.2k views
-
- 2 replies
- 1.4k views
-
- 2 replies
- 698 views
-
- 2 replies
- 729 views
-
- 2 replies
- 1.9k views
-
Topics
-
-
Posts
-
By KarlvonKoln · Posted
One-dip or naphtha should be safe, but are you sure it isn't magnetized? I would also check that. Although, if that balance is from an Elgin 760 0r 761, I would think it would have a hairspring of non-magnetic alloy. -
Hi, Is there a spell check function available when you are posting ? Regards CJ -
Hi John I just did a Seiko Lord-Matic a front loader without a split stem, I used a crystal lift to remove it, although I had to have it that tight I though I was going to break the lift before the crystal would budge. So I decided that the press would be a better option as I think crystals with tension rings resist a lot of compressing. I used a crystal press to repalce it and the bezel with no issues, obviuosly a different watch to the Omega. I just took my time and kept inspecting the installation progress bit by bit Regards CJ
-
Hello All, I’m replacing the crystal in an Omega Dynamic, # 165.039, which houses a cal 552, installed through the front of the case. The replacement Sterncreuz crystal is, like the original, with tension ring. I removed the crystal using a compressed air technique to pop it out. (I have a crystal lift, but I’m always fearful of marking the crystal edges and so avoid using it as much as possible). Now to the replacement - any tips on putting the crystal back in? Am I obliged to using my dreaded crystal lift to complete the task, or how about a crystal press? I’ve put lots of crystals in using a press, but never with the movement in the watch. The thought of using one with a front-loader makes me very nervous, with the fully assembled watch sitting under the press. How would more experienced folks proceed here? Any advice, gratefully received… John Down Under… -
By Neverenoughwatches · Posted
No thats straight out of the watch as i found it the balance wheel is almost as bad. I've never seen so much material removed.
-
