Watch Case Issues, Opening, Movement/Stem Removal, Case Parts, straps and bracelets
Discussing issues regarding the watch case including Opening, Closing, Movement Removal, Stem Removal, Pushers, Pendant Tubes etc...
You can also discuss subjects relating to watch straps and bracelets here.
Subforums
336 topics in this forum
-
- 6 replies
- 1.3k views
-
- 1 reply
- 958 views
-
- 2 replies
- 3.1k views
-
- 11 replies
- 2k views
-
- 2 replies
- 1.6k views
-
- 6 replies
- 2.5k views
-
- 3 replies
- 1.2k views
-
- 1 reply
- 2.4k views
-
- 4 replies
- 1.2k views
-
- 10 replies
- 2.4k views
-
- 3 replies
- 1.9k views
-
- 7 replies
- 2.3k views
-
- 2 replies
- 3.6k views
-
- 6 replies
- 1.7k views
-
- 3 replies
- 1.4k views
-
- 14 replies
- 7.8k views
-
- 4 replies
- 1.7k views
-
- 2 replies
- 1.1k views
-
- 13 replies
- 3.4k views
-
- 5 replies
- 1.2k views
-
- 7 replies
- 3.2k views
-
- 7 replies
- 1.6k views
-
- 5 replies
- 2.7k views
-
- 7 replies
- 2.7k views
-
- 2 replies
- 1.9k views
-
Topics
-
-
Posts
-
Unfortunately after much investigation, apparently the coil has been discontinued! Shall I get my service guy to try the solder or the conductive paint? 🎨 Final recommendation please🙏 -
Here are the pics of the bridge. Looks correct, but as soon as I screw on the rotor, the watch stops. Video here: https://1drv.ms/v/s!ArG5E62RGctxjokY5ws85BzuJLVakA Pics. Might have figured it out. I have been working on this watch for a while and since I got it as a non runner in a terrible shape, there was no guarantee that parts were proper. I think the main screw that was used on the rotor was too long, so it was stopping the main train. As soon as I fished out a much shorter and larger headed screw, things were good again. Please celebrate with me. -
By KarlvonKoln · Posted
One-dip or naphtha should be safe, but are you sure it isn't magnetized? I would also check that. Although, if that balance is from an Elgin 760 0r 761, I would think it would have a hairspring of non-magnetic alloy. -
Hi, Is there a spell check function available when you are posting ? Regards CJ -
Hi John I just did a Seiko Lord-Matic a front loader without a split stem, I used a crystal lift to remove it, although I had to have it that tight I though I was going to break the lift before the crystal would budge. So I decided that the press would be a better option as I think crystals with tension rings resist a lot of compressing. I used a crystal press to repalce it and the bezel with no issues, obviuosly a different watch to the Omega. I just took my time and kept inspecting the installation progress bit by bit Regards CJ
-
