Cleaning / De-Greasing Techniques - including cleaning products
Discussing cleaning and de-greasing of watch movements including products used
103 topics in this forum
-
- 3 replies
- 599 views
-
- 5 replies
- 3.7k views
-
- 10 replies
- 2.8k views
-
- 3 replies
- 2.2k views
-
- 115 replies
- 18.8k views
-
- 22 replies
- 1.2k views
-
- 9 replies
- 7.3k views
-
- 0 replies
- 1.2k views
-
- 17 replies
- 2.7k views
-
- 21 replies
- 2.1k views
-
- 35 replies
- 13.8k views
-
- 18 replies
- 2.1k views
-
- 1 reply
- 1.3k views
-
- 3 replies
- 2.2k views
-
- 16 replies
- 2.7k views
-
- 30 replies
- 4.3k views
-
- 4 replies
- 3.1k views
-
- 7 replies
- 2.5k views
-
- 9 replies
- 2.5k views
-
- 4 replies
- 1.4k views
-
- 18 replies
- 2.2k views
-
- 12 replies
- 2.5k views
-
- 2 replies
- 2k views
-
- 10 replies
- 3.6k views
-
- 14 replies
- 584 views
-
Topics
-
-
Posts
-
-
-
-
By coreymsnow · Posted
Hah! Well, California will have to do. Lived in TX for a brief period back in the early 70s, though, so maybe that counts. 🙂 Funny you should mention making vacuum tubes- I've actually tinkered with that! It's REALLY tough to do, and I've never made one more complicated than a simple diode that barely worked, but I have played around at it. But there's just no infrastructure for vacuum tube fabrication. I can get a lathe and learn how to use it to make complex parts, and while it might take a while to learn- and money to get the equipment, of course- it is possible to do more or less "off the shelf". But vacuum tubes, not so much. There are a few folks out there doing some crazy cool work with bespoke tubes, but they have setups that are far beyond what I can manage in my environment and it's mostly stuff they built by hand. I also have been playing with making piezoelectric Rochelle Salt crystals to replace ancient vacuum tube turntable needles- nobody's made those commercially for probably 60 years. I'm a sucker for learning how to do weird things no one does any more so I can make things no one uses work again. (I think this is drifting off the topic of lathes, lol). -
By LittleWatchShop · Posted
You shoulda been born in Texas. Tough to make a vacuum tube though. You can substitute with a MOSFET eq ckt I guess. I was playing around making a pinion the other day. More to it than meets the eye.
-
