Chat About Watches & The Industry Here
Discuss anything about watches and the watch industry.
2415 topics in this forum
-
- 1 reply
- 2.6k views
-
- 1 reply
- 4k views
-
- 1 reply
- 8.1k views
-
- 1 reply
- 6.7k views
-
- 1 reply
- 2.1k views
-
- 1 reply
- 2.4k views
-
- 1 reply
- 1.8k views
-
- 1 reply
- 2k views
-
- 1 reply
- 3.1k views
-
- 1 reply
- 2.6k views
-
- 1 reply
- 2.5k views
-
- 1 reply
- 1.9k views
-
- 1 reply
- 2.7k views
-
- 1 reply
- 1.5k views
-
- 1 reply
- 1.8k views
-
- 1 reply
- 2.1k views
-
- 1 reply
- 4.8k views
-
- 1 reply
- 1.5k views
-
- 1 reply
- 3.6k views
-
- 1 reply
- 2.9k views
-
- 1 reply
- 1.9k views
-
- 1 reply
- 3.3k views
-
- 1 reply
- 2.5k views
-
- 1 reply
- 1.8k views
-
- 1 reply
- 2.6k views
-
Topics
-
-
Posts
-
Sorry I didn't see that in your original post. Done some searching but nothing at the moment. -
-
Nice @AndyGSi. Since you have one on the bench, can you confirm if the other pillar screws would fit that hole's diameter & thread as I was speculating? In case the screw isn't there.
-
To me the screw looks to be their, just not tightened down. Photos without & with screw.
-
I learned one other thing yesterday watching a video from Alex Hamilton, which was to test the end shake of the balance staff BEFORE mounting it in the balance wheel. He also suggested setting it in the baseplate jewel and looking at the tilt angle (5 degrees being ideal). I wish I had done this with the balance staff currently installed!
-
