Relax Zone: Chat About Anything Here
Talk about whatever you fancy within the forum rules, not just about watches.
BUT: If you wish to start a topic relating to watch repair then please find the appropriate section here.
SECTION RULES
This section is for those who wish to relax and chit chat about whatever.
BUT PLEASE: Do not post topics here regarding watch repair, you can find an appropriate section for any watch repair topics here. Thank you for your understanding.
622 topics in this forum
-
- 3 replies
- 1.4k views
-
- 31 replies
- 7.2k views
-
- 14 replies
- 1.7k views
-
- 6 replies
- 1.6k views
-
- 10 replies
- 1.6k views
-
- 14 replies
- 2.7k views
-
- 2 replies
- 2k views
-
- 12 replies
- 2.4k views
-
- 28 replies
- 6.2k views
-
- 4 replies
- 1.3k views
-
- 57 replies
- 9.7k views
-
- 7 replies
- 1.5k views
-
- 3 replies
- 1.8k views
-
- 8 replies
- 1.7k views
-
- 4 replies
- 1.8k views
-
- 11 replies
- 2.4k views
-
- 4 replies
- 3.2k views
-
- 10 replies
- 1.6k views
-
- 3 replies
- 1.2k views
-
- 14 replies
- 3.3k views
-
- 7 replies
- 1.6k views
-
- 3 replies
- 1.3k views
-
- 4 replies
- 1.4k views
-
- 4 replies
- 1.9k views
-
- 13 replies
- 1.9k views
-
Topics
-
-
Posts
-
Any other thoughts on how I can get a replacement coil? Any “hidden” or unknown physical shops (in Australia or elsewhere) that might have them in stock (but not always online)? -
I discovered this last night when I printed my model, I'll try and tweak the design a little and re-post here -
That could work - two blunt pressure points would spread out the force required in order to reduce damage, and two small pins should fit slightly angled through the inner coil of the spring. I was thinking about this while working on other chores and had a crazy thought when I saw a can of expanding rigid sprayable foam, but who'd want to have to clean out the barrel and spring after that? -
That's very observant of you, Nev & that the 4th wheel is from another movement & has been dished to fit does seem a more likely explanation. Thanks for the education re calculating the rate & spring frequency. In the meantime, spurred by your earlier comnent, I risked a further tinker with the balance spring, cleaning it, fully un-kinking the last few cms (I'd been worried about breaking it first time round) & pinning it at the very end. The clock now seems to be running slow when the regulator is in that position so some progress at last.....Many thanks, once again! -
By rjenkinsgb · Posted
Snap! I recently finished my Gruen 510 movement - though the case for mine is in a rather sad state; I'm going to try re-plating it (in nickel, it's not a gold one). Re. the screws, I got a few of the one gram mixed batches from ebay. I've only needed a couple of screws for things so far, both rare, minuscule types - but both in the mix, after enough time sorting through them! The ones such as normal bridge screws are quite common in those lots.
-
