Relax Zone: Chat About Anything Here
Talk about whatever you fancy within the forum rules, not just about watches.
BUT: If you wish to start a topic relating to watch repair then please find the appropriate section here.
SECTION RULES
This section is for those who wish to relax and chit chat about whatever.
BUT PLEASE: Do not post topics here regarding watch repair, you can find an appropriate section for any watch repair topics here. Thank you for your understanding.
702 topics in this forum
-
- 5 replies
- 3.8k views
-
- 12 replies
- 3.2k views
-
- 16 replies
- 4.5k views
-
- 10 replies
- 3.8k views
-
- 11 replies
- 4.1k views
-
- 5 replies
- 2.8k views
-
- 10 replies
- 2.8k views
-
- 11 replies
- 5.3k views
-
- 7 replies
- 2.7k views
-
- 11 replies
- 6.2k views
-
- 8 replies
- 3.1k views
-
- 6 replies
- 2.3k views
-
- 4 replies
- 3k views
-
- 7 replies
- 2.7k views
-
- 16 replies
- 3.5k views
-
- 23 replies
- 5k views
-
- 5 replies
- 4k views
-
- 9 replies
- 3.5k views
-
- 26 replies
- 8.2k views
-
- 10 replies
- 4.6k views
-
- 12 replies
- 3k views
-
- 7 replies
- 3.1k views
-
- 10 replies
- 4.2k views
-
- 2 replies
- 1.6k views
-
- 8 replies
- 3.1k views
-
Topics
-
-
Posts
-
Do you have a part number for the bearing shim lock tool? -
Yes in my opinion the 3/4HP is plenty but it’s your decision & yes it does come with speed control but foot operation so my reason for changing to potentiometer was because my leg shakes so it was like me revving the lathe & anyway I prefer to set the speed. I & a few others that I recommended the motor to run a Pultra 10mm lathe so if you have a 6 or 8mm B & L then it will be plenty, if you have seen any of my videos you will have seen that when using a graver I run quite slow without any problems. Dell -
-
No, I'm definitely not up to Clickspring's standard. I put my indexing kit together after buying the late W.R. Smith's clock making DVDs. The setup is his concept, and the contraption is just my implementation of it. -
Hi All, I’m having a hard time finding a balance assembly or even a working donor movement for a Gruen 330. Any leads appreciated. Gruen doesn’t stamp the caliber number of the movement but lust in the case back.
-
