Watch Parts, Sourcing Parts, Movements, Materials and Lubrication Products
Discussing watch parts, the sourcing of watch parts and movements, and products required to repair and service watch movements
409 topics in this forum
-
- 4 replies
- 876 views
-
- 0 replies
- 938 views
-
- 5 replies
- 960 views
-
- 0 replies
- 785 views
-
- 4 replies
- 687 views
-
- 5 replies
- 1.1k views
-
- 3 replies
- 779 views
-
- 2 replies
- 635 views
-
- 15 replies
- 2k views
-
- 0 replies
- 674 views
-
- 0 replies
- 592 views
-
- 7 replies
- 601 views
-
- 1 reply
- 826 views
-
- 3 replies
- 677 views
-
- 5 replies
- 1.4k views
-
- 2 replies
- 719 views
-
- 6 replies
- 653 views
-
- 3 replies
- 900 views
-
- 9 replies
- 1.4k views
-
- 2 replies
- 788 views
-
- 4 replies
- 1.1k views
-
- 4 replies
- 1.4k views
-
- 6 replies
- 1.3k views
-
- 1 reply
- 1.1k views
-
- 14 replies
- 2.8k views
-
Topics
-
-
Posts
-
Yep, that's exactly how it should fit. The reamer shank is tapered and the socket in the spindle is also tapered so that the one centers in the other and is gripped tightly. If there is any wobble when the reamer is seated as far it will go then there is a problem. The cross hole in the spindle is to allow you the push the reamer back out again. If the reamer seated much deeper then it would limit the access for pushing it back out again. Here is one of mine for comparison. -
By RichardHarris123 · Posted
I think it should be the other way round, thanks to you. -
You have been a great help to me on many occasions. Thank you for the offer… -
By Hawaiikook808 · Posted
Another Question. Does this reamer look like it fits the reamer plunger? This one and all the others feel like they should push in all the way. Are they made like that so they don't turn or move when reaming a hole? Thanks. Frank -
Yes, it "should", but there was no way to get the springs out of my cal 627 without bending them. The ends were too big for the slots in the chaton. Whether they left the factory like that, or someone fitted new springs ..... 🥴
-
