Watch Parts, Sourcing Parts, Movements, Materials and Lubrication Products
Discussing watch parts, the sourcing of watch parts and movements, and products required to repair and service watch movements
412 topics in this forum
-
- 5 replies
- 3.2k views
-
- 4 replies
- 1.1k views
-
- 21 replies
- 3.6k views
-
- 1 reply
- 917 views
-
- 6 replies
- 1.9k views
-
- 40 replies
- 3.7k views
-
- 11 replies
- 2.6k views
-
- 10 replies
- 5.5k views
-
- 9 replies
- 9.1k views
-
- 17 replies
- 13.4k views
-
- 6 replies
- 2.2k views
-
- 34 replies
- 10.1k views
-
Topics
-
-
Posts
-
By ManSkirtBrew · Posted
Still haven't gotten around to getting stems or screws, but I did make my first attempt at polishing a case. I just used a soft mop and rouge to reduce my odds of ruining them, and I think they came up pretty nice. Also gave the crystals a polish on the same wheel while I was at it. They were both very badly scratched up. The one on the left is fairly beat up, but it'll still make for a decent presentation. -
-
-
By Neverenoughwatches · Posted
Determined that the nos staffs are the correct length for the movement by fitting the just the staff and i should be able to find a wheel and hairspring to fit. Problem is the roller hole is too large. -
-
