Watch Cleaning Machines / Ultrasonic Cleaners / Case Refinishing
Discuss watch cleaning machines, ultrasonic machines and case refinishing.
87 topics in this forum
-
- 5 replies
- 1.4k views
-
- 9 replies
- 1.3k views
-
- 16 replies
- 1.3k views
-
- 5 replies
- 1.3k views
-
- 3 replies
- 1.3k views
-
- 18 replies
- 1.3k views
-
- 3 replies
- 1.2k views
-
- 13 replies
- 1.2k views
-
- 3 replies
- 1.2k views
-
- 4 replies
- 1.2k views
-
- 8 replies
- 1.1k views
-
- 0 replies
- 1.1k views
-
- 5 replies
- 1.1k views
-
- 2 replies
- 1k views
-
- 6 replies
- 1k views
-
- 0 replies
- 1k views
-
- 3 replies
- 1k views
-
- 9 replies
- 999 views
-
- 3 replies
- 968 views
-
- 4 replies
- 957 views
-
- 4 replies
- 950 views
-
- 4 replies
- 933 views
-
- 3 replies
- 901 views
-
- 5 replies
- 899 views
-
- 9 replies
- 860 views
-
Topics
-
-
Posts
-
Unfortunately after much investigation, apparently the coil has been discontinued! Shall I get my service guy to try the solder or the conductive paint? 🎨 Final recommendation please🙏 -
Here are the pics of the bridge. Looks correct, but as soon as I screw on the rotor, the watch stops. Video here: https://1drv.ms/v/s!ArG5E62RGctxjokY5ws85BzuJLVakA Pics. Might have figured it out. I have been working on this watch for a while and since I got it as a non runner in a terrible shape, there was no guarantee that parts were proper. I think the main screw that was used on the rotor was too long, so it was stopping the main train. As soon as I fished out a much shorter and larger headed screw, things were good again. Please celebrate with me. -
By KarlvonKoln · Posted
One-dip or naphtha should be safe, but are you sure it isn't magnetized? I would also check that. Although, if that balance is from an Elgin 760 0r 761, I would think it would have a hairspring of non-magnetic alloy. -
Hi, Is there a spell check function available when you are posting ? Regards CJ -
Hi John I just did a Seiko Lord-Matic a front loader without a split stem, I used a crystal lift to remove it, although I had to have it that tight I though I was going to break the lift before the crystal would budge. So I decided that the press would be a better option as I think crystals with tension rings resist a lot of compressing. I used a crystal press to repalce it and the bezel with no issues, obviuosly a different watch to the Omega. I just took my time and kept inspecting the installation progress bit by bit Regards CJ
-
