Watch Case Tools - Glass Fitting/Removal - Case Opening/Closing
Discussing tools in relation to the watch case including glass fitting and removal, opening and closing of watch cases, crowns/pendant tubes/pushers etc...
36 topics in this forum
-
- 8 replies
- 539 views
-
- 6 replies
- 1.1k views
-
- 0 replies
- 323 views
-
- 0 replies
- 329 views
-
- 2 replies
- 361 views
-
- 2 replies
- 841 views
-
- 0 replies
- 358 views
-
- 8 replies
- 865 views
-
- 0 replies
- 881 views
-
- 7 replies
- 818 views
-
- 40 replies
- 2.7k views
-
- 6 replies
- 748 views
-
- 0 replies
- 430 views
-
- 25 replies
- 2.4k views
-
- 15 replies
- 2.6k views
-
- 0 replies
- 801 views
-
- 2 replies
- 1.2k views
-
- 2 replies
- 1.1k views
-
- 4 replies
- 855 views
-
- 7 replies
- 1.9k views
-
- 0 replies
- 708 views
-
- 2 replies
- 1.2k views
-
- 5 replies
- 1.2k views
-
- 9 replies
- 1.4k views
-
- 15 replies
- 2.8k views
-
Topics
-
-
Posts
-
By ManSkirtBrew · Posted
Lubed up, back together (minus the one screw), and I'd say not a bad result! Going to give it a day or two to run in while I clean up the case and regulate it again, but off to a good start. -
So it runs and keeps good time even with that train wheel. You are lucky I would point out to the owner about the wheel, just in case at some point they take it to a different clock maker. -
Thank you for your introduction and welcome to this friendly forum. We all look forward to your contributions and continued involvement. As they are screws to hold links it is possible they are false and do nothing. Already said photos are needed.
-
By watchweasol · Posted
Hi New. More of a get you out of a hole than a bodge. There is no substitute for a new coil. -
-
