Your Current Projects and Achievements
If you would like to discuss your current projects or show off your latest watch repair achievement and it is not an actual walkthrough please post here.
SECTION RULES
This section if for posting the results of your labours with a particular project. If you wish to post a full walkthrough then please use this section.
540 topics in this forum
-
- 5 replies
- 1.2k views
-
- 9 replies
- 1.2k views
-
- 10 replies
- 1.2k views
-
- 10 replies
- 1.2k views
-
- 0 replies
- 1.2k views
-
- 0 replies
- 1.2k views
-
- 4 replies
- 1.2k views
-
- 13 replies
- 1.2k views
-
- 3 replies
- 1.2k views
-
- 0 replies
- 1.1k views
-
- 2 replies
- 1.1k views
-
- 6 replies
- 1.1k views
-
- 4 replies
- 1.1k views
-
- 13 replies
- 1.1k views
-
- 4 replies
- 1.1k views
-
- 5 replies
- 1.1k views
-
- 8 replies
- 1.1k views
-
- 17 replies
- 1.1k views
-
- 1 reply
- 1.1k views
-
- 2 replies
- 1.1k views
-
- 1 reply
- 1.1k views
-
- 4 replies
- 1.1k views
-
- 3 replies
- 1.1k views
-
- 3 replies
- 1.1k views
-
- 0 replies
- 1.1k views
-
Topics
-
-
Posts
-
-
By Neverenoughwatches · Posted
🤔 so how is this relevant to the crystal coming out. I've never heard of a crystal that comes out through the back. ? -
By Neverenoughwatches · Posted
Very kind of you chief, the problem is the roller table and knowing if it will interact with the fork. Another roller for this calibre is what i probably need the most. It will have to sit for now while I'm away on holiday for a week. Its an interesting little piece with the cardboard dial which i still haven't got to the bottom of yet. Curious as the OP said his 554 was marked Invicta and this made up dial is also branded Invicta. -
By Neverenoughwatches · Posted
Looking at Nev's graph the thinner longer spring is delivering less torque but over a longer period of time. For this to happen and completely unwind itself increasing the power reserve the friction through the train must be less than if a specified spring were fitted. -
Ok. Update. Checked under a microscope, there is no lip, it just looks like one. So, I'm convinced I need to back the ring out. I'll need to make a tool of some sort.
-
