Watch Case Tools - Glass Fitting/Removal - Case Opening/Closing
Discussing tools in relation to the watch case including glass fitting and removal, opening and closing of watch cases, crowns/pendant tubes/pushers etc...
50 topics in this forum
-
- 32 replies
- 1.5k views
-
- 11 replies
- 1.8k views
-
- 10 replies
- 764 views
-
- 8 replies
- 3.8k views
-
- 3 replies
- 526 views
-
- 6 replies
- 608 views
-
- 0 replies
- 420 views
-
- 3 replies
- 1.4k views
-
- 20 replies
- 1.3k views
-
- 1 reply
- 449 views
-
- 4 replies
- 710 views
-
- 9 replies
- 1.2k views
-
- 1 reply
- 586 views
-
- 24 replies
- 3.8k views
-
- 44 replies
- 7.9k views
-
- 2 replies
- 2.1k views
-
- 21 replies
- 3.4k views
-
- 8 replies
- 2.5k views
-
- 0 replies
- 1.4k views
-
- 7 replies
- 2.9k views
-
- 2 replies
- 1.5k views
-
- 8 replies
- 3.8k views
-
- 2 replies
- 2.8k views
-
- 0 replies
- 1.5k views
-
- 0 replies
- 2.1k views
-
Topics
-
-
Posts
-
Hi How can I clean this watch case rubber ring? It got the melted gasket on it... -
By Sebastiaan · Posted
Thank you for the reading material -
By watchweasol · Posted
Hi one assumes by the addition of the pictures you have the technical sheet for this watch. As mentioned by @HectorLooi center wheel canon pinion .take it down again and install only the parts required to set the hacking and turn the hands checking at each stage for correct operation. -
By watchweasol · Posted
Hi if it is a Swiss made watch badged by ingersoll (eubauches) ther is likely a makers mark and number under the balance that may help . If you open it up and post a picture of the movement plus Any numbers. -
picky picky…You’re looking for an item that people perceive to have value. Good luck hunting…
-
