Introduce Yourself Here
New to the community? We like to know who we are chatting with :)
So why not introduce yourself here first!
4743 topics in this forum
-
- 4 replies
- 1.5k views
-
- 4 replies
- 1.6k views
-
- 3 replies
- 2.5k views
-
- 9 replies
- 3.4k views
-
- 2 replies
- 3.4k views
-
- 3 replies
- 2.5k views
-
- 5 replies
- 1.8k views
-
- 6 replies
- 2.6k views
-
- 4 replies
- 1.4k views
-
- 3 replies
- 948 views
-
- 3 replies
- 656 views
-
- 7 replies
- 1.9k views
-
- 1 reply
- 1.1k views
-
- 2 replies
- 803 views
-
- 3 replies
- 1k views
-
- 5 replies
- 2.4k views
-
- 4 replies
- 1.4k views
-
- 2 replies
- 1.4k views
-
- 2 replies
- 3k views
-
- 3 replies
- 2.1k views
-
- 7 replies
- 1.4k views
-
- 11 replies
- 9.3k views
-
- 0 replies
- 1.2k views
-
- 2 replies
- 1.2k views
-
- 2 replies
- 1.4k views
-
Topics
-
-
Posts
-
Welcome to the forum. I'm not aware of an acrylic that size you could use a crystal lift on. Can you post a photo of the watch along with the side profile. -
By LittleWatchShop · Posted
When turning staffs, a JKA is invaluable and expensive. Fortunately, I inherited mine. There are crude alternatives to a lathe...like chucking something up in a Makita drill motor and using various grit sandpaper to make a pin. Won't turn a staff that way!! But, you can make a pin. -
Now that I think about it, I can probably just file down the pin carefully to the point where it fits. Is that too much of a hack? -
-
You asked for an introduction. I have a Timex Marlin with a cracked crystal. (already said all this--sorry for the repeat in the introduction) I bought a Ling Hui universal crystal puller that was not universal. Can I find a larger puller or is there a different solution. RickG
-
