Introduction and help requested getting started with small lathe work
-
Recently Browsing
- No registered users viewing this page.
-
Topics
-
Posts
-
Your setup is correct. The smallest diameter of one pulley must correspond with the largest of the other one, else not speed variation. Frank
-
By RichardHarris123 · Posted
Look at his T shirt about 22 minutes in. https://youtu.be/GSYQNnZ-MNE?si=M_s0I-TE4I_HRilY
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.