Introduce Yourself Here
New to the community? We like to know who we are chatting with :)
So why not introduce yourself here first!
4157 topics in this forum
-
- 2 replies
- 1.3k views
-
- 1 reply
- 848 views
-
- 4 replies
- 108 views
-
- 5 replies
- 116 views
-
- 3 replies
- 84 views
-
- 9 replies
- 294 views
-
- 7 replies
- 836 views
-
- 4 replies
- 2.3k views
-
- 3 replies
- 1.6k views
-
- 2 replies
- 1.8k views
-
- 3 replies
- 2.7k views
-
- 0 replies
- 114 views
-
- 5 replies
- 1.3k views
-
- 5 replies
- 935 views
-
- 6 replies
- 1.1k views
-
- 3 replies
- 242 views
-
- 5 replies
- 1.3k views
-
- 1 reply
- 2.2k views
-
- 6 replies
- 1.7k views
-
- 1 reply
- 709 views
-
- 2 replies
- 692 views
-
- 6 replies
- 711 views
-
- 2 replies
- 390 views
-
- 6 replies
- 1.1k views
-
- 1 reply
- 182 views
.thumb.png.f90dbf035d35248cb483d466310379d3.png)
-
Topics
-
-
Posts
-
Any other thoughts on how I can get a replacement coil? Any “hidden” or unknown physical shops (in Australia or elsewhere) that might have them in stock (but not always online)? -
I discovered this last night when I printed my model, I'll try and tweak the design a little and re-post here -
That could work - two blunt pressure points would spread out the force required in order to reduce damage, and two small pins should fit slightly angled through the inner coil of the spring. I was thinking about this while working on other chores and had a crazy thought when I saw a can of expanding rigid sprayable foam, but who'd want to have to clean out the barrel and spring after that? -
That's very observant of you, Nev & that the 4th wheel is from another movement & has been dished to fit does seem a more likely explanation. Thanks for the education re calculating the rate & spring frequency. In the meantime, spurred by your earlier comnent, I risked a further tinker with the balance spring, cleaning it, fully un-kinking the last few cms (I'd been worried about breaking it first time round) & pinning it at the very end. The clock now seems to be running slow when the regulator is in that position so some progress at last.....Many thanks, once again! -
By rjenkinsgb · Posted
Snap! I recently finished my Gruen 510 movement - though the case for mine is in a rather sad state; I'm going to try re-plating it (in nickel, it's not a gold one). Re. the screws, I got a few of the one gram mixed batches from ebay. I've only needed a couple of screws for things so far, both rare, minuscule types - but both in the mix, after enough time sorting through them! The ones such as normal bridge screws are quite common in those lots.
-
