Jump to content

Hello from Carshalton


BertsBoy

Recommended Posts

Hi,

I read it's considered polite to introduce myself here:  I'm an amateur watch maker and my Dear Old Dad (Bert), was a professional horologist for over 60 years.  I took up the 'sport' when I retired after 43 years at the BBC.

Hope that's enough and thanks for letting me in 😀

Martin

  • Like 1
Link to comment
Share on other sites

Thanks to all for the welcome to WRT.  It's been very absorbing going through all the info and posts over the last week or so!

My profile picture btw is of my Dad (Bert), at watchmakers' school back in 1946 when he was 16.

Thanks again and I hope to be able to make contributions of some interest in due course.

Martin

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • I must say I'm the same, buying a complete set of something saves a lot of time and effort but there is a certain type of gratification for me hunting out all the add-ons.  Ps hands down having a psychotherapist for a wife is way better than having a psychopath for a wife in my experience 🙄  
    • Mark, good info.   My attempted photo through 10x loupe.  Not the best but an effort.  As much as this sounds dumb, the HS has increased its gap from the the cock.  And, seems to spin 3 times longer.  I think I have some residual fiber from my pegging.  What is small enough to clean out these pivots? Or is this where the L&R correct cleaning product helps?  Liquid movement will ensure the pivot holes are clear?  Yup, I have 3x cheaters and the 10x Loupe.  I will have another run at examination.  Everflex green sticks.  Quick google, will have to dig deeper.  Perhaps that is the key to clean pivot holes.   Noted on mixing Naptha based solvent and IPA, water based.  I have a gallon of Coleman White Fuel for about 15 years.  Time to use it and use as rinse.  I stumbled on a L&R Master for $20 with all original L&R jars and lids.  Just have to research basket, a topic for a different post and I am forcing myself to not get distracted by this premature acquisition and practice with my tools. For now, the main spring will not get attention.  After I put the watch together and running, a small miracle, I don't think the main spring to be a major detractor for practice.  My plan is to have my watch maker service my main spring.  Support local small business and he always shares knowledge when I visit.
    • Hi Ammar, I couldn't find anything about the chemical resistance of PLA to naphtha. According to these sources it doesn't rate too well. I think that your concern is correct. If you did a final rinse in IPA after the parts are out of the basket my guess is it would be fine. I have no affiliation in either of these companies. https://prusament.com/chemical-resistance-of-3d-printing-materials/ https://www.filamentive.com/chemical-resistance-of-3d-printing-filament/
    • Yes that is right. No offence intended. 
×
×
  • Create New...