Toolmaking, Tools Restoration, Bespoke Tools and 3D Printing Tools
Making your own tools? This section covers traditional toolmaking and restoration, manufacturing bespoke tools to solve watchmaking issues and using modern technologies such as 3D printing to create new tools.
Subforums
-
- 258
- posts
92 topics in this forum
-
- 0 replies
- 2.7k views
-
- 8 replies
- 5.8k views
-
- 10 replies
- 1.2k views
-
- 11 replies
- 1k views
-
- 20 replies
- 776 views
-
- 4 replies
- 4.7k views
-
- 1 reply
- 1.9k views
-
- 7 replies
- 743 views
-
- 0 replies
- 1.7k views
-
- 1 reply
- 2.8k views
-
- 17 replies
- 4.5k views
-
- 0 replies
- 1.6k views
-
- 6 replies
- 3.2k views
-
- 0 replies
- 1.8k views
-
- 2 replies
- 480 views
-
- 0 replies
- 1.1k views
-
- 7 replies
- 1.7k views
-
Topics
-
-
Posts
-
Hi,what is the model number for that case? Is possible I have one for service with me,if so then I can measure for you the factory size of the bezel -
By RichardHarris123 · Posted
My hair went in my early twenties, shaved it off and never looked back. -
It can be a good idea to replace the gasket as well, especially if has any kind of damage. If it's a very tight fit between the gasket and the crystal, a thin layer of silicon grease on the gasket can help a lot. Keep us updated! -
Double checked, definitely a fake bezel. It has a thin plastic gasket that creates the seal for the crystal. I went ahead and gave the case a good cleaning, and light polish. Now Im just hoping I can install the new crystal with out screwing up! I will likely be putting it in tomorrow night. -
Try the gel we used during covid. Works really great for removing gasket-turned-to-tar residue.
-
