Jump to content

An Olma From The 1940S


WillFly

Recommended Posts

Cheapskate that I am, I can't resist picking up a cheapie on eBay now and then and, for not much more than the price of a round of drinks, got this watch from the 1940s - which arrived this morning. The make is "Olma", a Swiss brand registered in 1926 but now obviously owned by an Asian company. Olma was probably in the lower half of the Swiss watchmaking hierarchy, using good, dependable movements. The one in this watch is an AS 1287 - pre-incabloc, with a typical 1940s, quasi-military dial.

 

post-64-0-89820700-1433862172_thumb.jpg

post-64-0-44976100-1433862176_thumb.jpg

  • Like 1
Link to comment
Share on other sites

It's always tempting to try to repair some of the obvious signs of age - case, crystal, dial, hands, etc. In this instance, the dial is good and the hands are passable. (The strap came fitted new by the seller). But I'm always cautious in these cases.

 

The case rear is good - quite well chromed and clean - which leaves the bezel and the crystal. The bezel is of a gold-finished base metal and is well "brassed". Not much can be done there other than re-chrome it - which I won't do because it's not worth it. But I might try some very careful and gentle polishing with Autosol. The crystal is high-domed - typical for its period - and has slight scratching across the surface, but is not yellowed (being glass). So I'm actually inclined to leave it - unusual for me because I normally like to replace them.

 

The movement was serviced by the seller - whatever that might mean. It was set by me this morning and is currently correct almost to the second, and the regulator is almost bang in the middle of the -/+ mark. So - no messing with this one.

 

It is what it is - a nice, simple, 75-year old wristwatch that cost me very little.

  • Like 1
Link to comment
Share on other sites

  • 3 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • Yes i did eventually realise that the oil will act as a barrier, I'm sure the discussion will continue. Ive had two oleophobic coffees ( added coconut ) and in the meantime i have this just delivered to take my mind off epilame for the time being. My favourite type of dial, its a beautiful looking watch traditional English made and it runs,  the ticktock is phenomenal,  i can hear it across my living room .  You wont believe how much it was.
    • Imm going to close the discussion by attaching the photo of my super-titanium after several vicissitudes finally working. Purchased as not working I replaced the battery and for a stroke of luck I found its semi-new solar panel which, having verified its operation, seems to recharge the accumulator perfectly. I had taken this watch almost by bet, with 40 euros I brought it back to life. The initial half idea was to resell it to finance another purchase, but.. it's definitely a nice item. It would need to check the impermeability but it's a pleasure to see it on the wrist 😃
    • In fact the secret is to go gently and find the way without forcing, and the movement enters without problems
    • Yea a have given it a full service this movement is chinese 2813 whats the lift angle for this movement does anyone knows  and how  do a remove the default  of 52 degrees on my timegrapher?   Hi you said my lift angle is default how do a remove this from my timegrapher?
    • Sure! Some very accomplished repairers never use epilame! I have often wondered if it is worth the trouble. Not using epilame will shorten the service intervals though, but that could be better perhaps both for the owner and the repairer!? Speaking of oiling, I just read this: After WWII in the 1950s the first Synthetic Oils came on the market. Most watchmakers did not rush to use these oils since they were bad for business now that the watch serviced with Synthetic oil would not come back to him for service for another 5-7 years he would lose a lot of income. ~Ofrei.com   Anyway, I wouldn't be surprised if it would be more correct to think of epilame as a binder rather than a repellant. Until convinced otherwise that's how I will think of epilame.
×
×
  • Create New...