Watch Case Issues, Opening, Movement/Stem Removal, Case Parts, straps and bracelets
Discussing issues regarding the watch case including Opening, Closing, Movement Removal, Stem Removal, Pushers, Pendant Tubes etc...
You can also discuss subjects relating to watch straps and bracelets here.
Subforums
333 topics in this forum
-
- 1 reply
- 309 views
-
- 14 replies
- 1.8k views
-
- 2 replies
- 322 views
-
- 5 replies
- 600 views
-
- 2 replies
- 588 views
-
- 6 replies
- 2.7k views
-
- 16 replies
- 3.8k views
-
- 3 replies
- 683 views
-
- 9 replies
- 886 views
-
- 16 replies
- 1.2k views
-
- 1 reply
- 993 views
-
- 7 replies
- 494 views
-
- 13 replies
- 769 views
-
- 4 replies
- 806 views
-
- 8 replies
- 752 views
-
- 19 replies
- 24.2k views
-
- 2 replies
- 659 views
-
- 15 replies
- 4.7k views
-
- 7 replies
- 1.3k views
-
- 21 replies
- 1.1k views
-
- 3 replies
- 1.2k views
-
- 11 replies
- 1k views
-
- 0 replies
- 1.7k views
-
- 3 replies
- 875 views
-
- 1 reply
- 1.9k views
-
Topics
-
-
Posts
-
It looks like this movement comes with a number of different shock settings. Emmywatch shows that it comes in versions with no shock settings, 'Incabloc', 'shock resist', and 'Supershock'. Perhaps the different settings position the impulse jewel/roller table in a non-ideal position relative to the pallet fork/guard pin. Are you able to check under high magnification if the pallet fork and roller table are able to operate without any interference? Just for fun I took a look and I have one FHF 70 in my collection, a West End Secundus with a non-shock protected FHF70. I had a note with the watch that said, "Movement is stamped 'FHF 70', but the FHF70 looks to have sub-seconds instead of center seconds movement (??)" but that a google search turned up both types for this movement. EDIT: I just took a look in my parts drawer and I have a few of these movements, both in center seconds and sweep seconds, but they all are non-shock protected. -
Any info on this watch would help. I know that it's sterling from London but I could not match the o letter date or make out makers mark. Is the movement maker Camberwell or Lamberwell? If I give it a twist it will run for about ten seconds. $45 yard sale find. I don't think that I want to service a fusee. What quality is it? -
Hello As I am learning, does anyone have any recommendations on Repair and sourcing in Gold Coast, Qld, Australia ? eg old Seiko coil 4002920 Thanks. Cheers, Ken -
-
By Neverenoughwatches · Posted
Lay out the minute wheel bridge jumper , the yoke and the setting lever. So we can get a good look at them . I have flume and the swiss parts catalogs.
-
