Parts Manufacture & Lathe Work
Discussing watch parts manufacturing and lathe turning.
21 topics in this forum
-
- 2 replies
- 3.1k views
-
- 1 reply
- 3.4k views
-
- 4 replies
- 1.2k views
-
- 5 replies
- 855 views
-
- 0 replies
- 3.2k views
-
- 6 replies
- 1.2k views
-
- 5 replies
- 258 views
-
- 29 replies
- 1.5k views
-
- 4 replies
- 5.1k views
-
- 9 replies
- 1.5k views
-
- 21 replies
- 6.8k views
-
- 4 replies
- 762 views
-
- 1 reply
- 3.1k views
-
- 73 replies
- 18.3k views
-
- 57 replies
- 11k views
-
- 4 replies
- 2.5k views
-
- 35 replies
- 10.2k views
-
- 16 replies
- 733 views
-
- 45 replies
- 6.9k views
-
- 7 replies
- 4.5k views
-
- 11 replies
- 1.9k views
-
Topics
-
-
Posts
-
By rjenkinsgb · Posted
Again, EDTA solution as I mentioned above, or Evaporust. They attack oxides but not good metal. After some hours, all the rust should have gone. -
Hi How can I clean this watch case rubber ring? It got the melted gasket on it... -
By Sebastiaan · Posted
Thank you for the reading material -
By watchweasol · Posted
Hi one assumes by the addition of the pictures you have the technical sheet for this watch. As mentioned by @HectorLooi center wheel canon pinion .take it down again and install only the parts required to set the hacking and turn the hands checking at each stage for correct operation. -
By watchweasol · Posted
Hi if it is a Swiss made watch badged by ingersoll (eubauches) ther is likely a makers mark and number under the balance that may help . If you open it up and post a picture of the movement plus Any numbers.
-
