Introduce Yourself Here
New to the community? We like to know who we are chatting with :)
So why not introduce yourself here first!
4162 topics in this forum
-
- 3 replies
- 1.5k views
-
- 6 replies
- 710 views
-
- 6 replies
- 588 views
-
- 4 replies
- 849 views
-
- 4 replies
- 801 views
-
- 6 replies
- 810 views
-
- 5 replies
- 893 views
-
- 2 replies
- 653 views
-
- 4 replies
- 690 views
-
- 2 replies
- 542 views
-
- 7 replies
- 887 views
-
- 9 replies
- 1.2k views
-
- 4 replies
- 2k views
-
- 5 replies
- 1.4k views
-
- 4 replies
- 2.5k views
-
- 5 replies
- 1.1k views
-
- 3 replies
- 905 views
-
- 7 replies
- 1.2k views
-
- 3 replies
- 1.4k views
-
- 4 replies
- 1.2k views
-
- 2 replies
- 1.7k views
-
- 2 replies
- 1.1k views
-
- 9 replies
- 1.5k views
-
- 9 replies
- 1.3k views
-
- 5 replies
- 1k views
-
Topics
-
-
Posts
-
I overhauled a ladies Rolex and noticed erratic performance so I stripped in down again and did fault finding. This is what I saw. The lower jewel (the one in the plate) is cracked and the hole is too big. Before discovering this, I stripped down and re-cleaned the main-plate (and parts) by hand with a fine natural fiber brush. I somehow missed the fault the first time and cannot understand how it was still running. Perhaps re-cleaning it dislodged some pieces of the jewel widening the hole? I don't know. Now I need to replace the jewel but don't have a Seitz tool. The Rolex part is 2130-0913 and the top and bottom are the same. The part comes complete in brass setting with KIF elastor spring and cap jewel. Note: I have never replaced a jewel. I do have a good vintage stacking set that I've used quite a bit. Can I replace using a stacking set? Any suggestions would be greatly appreciated. -
Is there a tech sheet available for the 6601? I've only been able to find a parts list. If there isn't one, would there be one available that is close enough to follow along with? -
By Neverenoughwatches · Posted
I've used expanding foam for lots of things but i thinķ you got me on that one. -
By HectorLooi · Posted
This happened to me several years ago when I first got my barrel closing tool. In my eagerness to try out my new tool, I closed the cap without the arbor. I don't quite remember how I opened it. I might have used compressed air to pop the cap off. I sometimes use compressed air to open those "sealed" Seiko barrels. -
By LittleWatchShop · Posted
Welcome @Boggie46. I would encourage you to take a little time to learn the terminology of watch parts, e.g., "winder rod" is the "stem." It will help us to help you. I am curious as to how you removed the center seconds wheel.
-
