Help Identifying a Pocket Watch Movement (NON American?)
-
Recently Browsing
- No registered users viewing this page.
-
Topics
-
Posts
-
Hi mikepilk and JohnR725, Thanks for the the reply and advice. Though i don't have good experience in watch repairs except couple of Seikos i.e. 7009a & 6309 Repairs, but i am good at diagnosing and understanding the workings. I know the watch has been rusted badly, but if you get it for as cheap as $90 , where in good condition the cost is $1500. But i Promise you guys i will repair it and will share the picture when it be running soon. Regards. Usman
-
the hardware works fine, but I need to work on my side of the equation, have squashed a few cannon pinions trying to find that 'Goldilocks' zone between too much force and not enough.
-
My Horia clone is 4/4mm, I have seen 3/4mm on Ali but the 4/4mm is the more useful imo Tom
-
The Horia clones seem to have 3mm pushers and 4mm stumps - at least the ones I’m looking at have that listed in the specs. But who knows, perhaps there are various iterations and most don’t list their specs. I can’t find the specs for the 31001 listed anywhere. Would you be able to measure the diameter of both sections and us know? I suspect - but I don’t no for sure - that the stump is 4mm and the pusher is 3mm too. It would be interesting to confirm. Thanks Malocchio.
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.