Jump to content

Interesting Tissot


Recommended Posts

A lot of us in the watch hobby are aware of the fact that Tissot and Omega are quite closely related, one good example is the Tissot 2481 which is the same movement as the Omega 1481. Even the 10xx Omega's can sometimes be found branded as Tissot.

20220625_104645.thumb.jpg.d21123e0dfec544326d2dd3e63f2537a.jpg

I have this Tissot and while handling it recently I noticed that its bracelet clasp is signed Omega. Cool but I did not think anything about it... watch straps are easily swapped.

20220625_103810.thumb.jpg.b1833e339adeb541eb7e88d44ffd5978.jpg

 

Over the weekend I decided to look into the quickset which wasn't ...quicksetting. On this calibre, the quickset is by pushing in the crown. I decased the movement and cycled the quickset, my initial guess was that the stem was cut a hair too short and the crown did not have enough travel to activate the quickset. With the movement out of the case and the crown having unrestricted movement the issue with the quickset remained so it needed some further investigation under the dial. As I am a bit swamped with watch work I decided to reinstall the movement and come back to it some other time.

On blowing the inside of the case out with my puffer, I happened to notice this, the little Omega cartouche in the middle of the crystal inner. You will find this on most original acrylic crystals. I've never seen this before on Tissots.

20220625_103738.thumb.jpg.36b4347f86c9aefedde5268b80fa5549.jpg

Next I re-examined the caseback...

20220625_103917.thumb.jpg.f36f93ee097f4fc29a3038a4f2d037c1.jpg

Normal Tissot at first glance but it looked a bit unusual.

20220625_103947.thumb.jpg.8f84254ad10de6a294a4569e70992ce5.jpg

It seemed like it had been machined and then restamped.  On closer examination, I can make out a mark in the area circled below, can you see it?

20220625_104001.thumb.jpg.5ff207f03092df9ac59ea3b531604f35.jpg

Its a bit hard to see in the pic and even with the caseback in hand you really need to have the light at the correct angle but the Omega logo can be faintly seen!

My guess is that there were a surplus of cases/bands which was diverted to Tissot which then machined off the existing markings and engraved their own logo and numbers.

Anyway hope you guys enjoy this insight into the Tissot/Omega relationship!

20220602_144126.thumb.jpg.7d7f00c1b4aeec7261ab16d42025b8ca.jpg

Anilv

 

Edited by anilv
  • Like 3
Link to comment
Share on other sites

Here is my yard sail find front loader Tissot with a Tissot marked Omega movement and bracelet. Bracelet being SS does't belong on a gold plated watch but it's the same style as the Omega next to it.

IMG_5162.JPG

IMG_5163.JPG

IMG_5164.JPG

  • Like 2
Link to comment
Share on other sites

14 hours ago, JohnR725 said:

no pictures of the movement?

Hi John... I didnt mtake any because I was more focussed on the Omega related bits.

Should've but too late now, anyway a lot of Tissot 2481 pics on the net.

Anilv

Link to comment
Share on other sites

in a watch repair discussion group we really do like seeing watch movements.

then histories of watch companies are interesting. I have a link below and yes the two companies had relationships. One of the things that the Swiss have done is from time to time various groups organize and work together. I've heard that they all ask you have agreements not the so watches in various countries so that they basically some countries might even frown on unfair trade practices but they do what they do so that they can sell their watches and prosper in a business.

one of things I noticed as a lot of the watch companies including the Japanese ones it's like the other main brand and then they also have may be a lower grade a secondary brand. People don't always associate them as being related but they're not it's not like they both exist in the same building for instance they are considered separate company's

https://en.wikipedia.org/wiki/Tissot

then for those that like to see pictures of movements here's the Omega 1481

http://www.ranfft.de/cgi-bin/bidfun-db.cgi?10&ranfft&0&2uswk&Omega_1481

then for the tissot 2481

http://www.ranfft.de/cgi-bin/bidfun-db.cgi?10&ranfft&0&2uswk&Tissot_2481

interesting of the Omega doesn't really look like an Omega movement. Or at least what I would consider one of the classic Omega movements

then if you look at the parts list don't notice that yes a sizable quantity the components will interchange. I'm not going click on all of them it's conceivable that some may not interchange maybe

http://cgi.julesborel.com/cgi-bin/matcgi2?ref=TIS_2481

 

 

 

 

 

 

 

Link to comment
Share on other sites

21 hours ago, anilv said:

A lot of us in the watch hobby are aware of the fact that Tissot and Omega are quite closely related, one good example is the Tissot 2481 which is the same movement as the Omega 1481. Even the 10xx Omega's can sometimes be found branded as Tissot.

20220625_104645.thumb.jpg.d21123e0dfec544326d2dd3e63f2537a.jpg

I have this Tissot and while handling it recently I noticed that its bracelet clasp is signed Omega. Cool but I did not think anything about it... watch straps are easily swapped.

20220625_103810.thumb.jpg.b1833e339adeb541eb7e88d44ffd5978.jpg

 

Over the weekend I decided to look into the quickset which wasn't ...quicksetting. On this calibre, the quickset is by pushing in the crown. I decased the movement and cycled the quickset, my initial guess was that the stem was cut a hair too short and the crown did not have enough travel to activate the quickset. With the movement out of the case and the crown having unrestricted movement the issue with the quickset remained so it needed some further investigation under the dial. As I am a bit swamped with watch work I decided to reinstall the movement and come back to it some other time.

On blowing the inside of the case out with my puffer, I happened to notice this, the little Omega cartouche in the middle of the crystal inner. You will find this on most original acrylic crystals. I've never seen this before on Tissots.

20220625_103738.thumb.jpg.36b4347f86c9aefedde5268b80fa5549.jpg

Next I re-examined the caseback...

20220625_103917.thumb.jpg.f36f93ee097f4fc29a3038a4f2d037c1.jpg

Normal Tissot at first glance but it looked a bit unusual.

20220625_103947.thumb.jpg.8f84254ad10de6a294a4569e70992ce5.jpg

It seemed like it had been machined and then restamped.  On closer examination, I can make out a mark in the area circled below, can you see it?

20220625_104001.thumb.jpg.5ff207f03092df9ac59ea3b531604f35.jpg

Its a bit hard to see in the pic and even with the caseback in hand you really need to have the light at the correct angle but the Omega logo can be faintly seen!

My guess is that there were a surplus of cases/bands which was diverted to Tissot which then machined off the existing markings and engraved their own logo and numbers.

Anyway hope you guys enjoy this insight into the Tissot/Omega relationship!

20220602_144126.thumb.jpg.7d7f00c1b4aeec7261ab16d42025b8ca.jpg

Anilv

 

An interesting and lovely example of the history of Omega's and Tissot's collaboration to become the holding company SSIH in 1930. 👍

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • Hello good watch folk ,I  just fancied a light hearted discussion after my head was starting to spin over Epilame 😅. Specifically I'm meaning the sale of vintage watches, say nothing past the 1980s market. The stuff we see on ebay and other similar sites and found at carboots, curio shops etc. And are  we thinking its reaching a peak volume ?  Younger generations clearing out passed parents and grandparents possessions.  The younger folk are not as sentimental as the old fogies ( I'm now nearly at an age that i used to think was old fogie age ). When might it have started ?  i often wish i discovered the hobby much much sooner when selling your grandfathers pocket watch at a boot sale for a few quid was just a way to offload some tat. And when might it slow down. Thoughts anyone ?
    • Yes i did eventually realise that the oil will act as a barrier, I'm sure the discussion will continue. Ive had two oleophobic coffees ( added coconut ) and in the meantime i have this just delivered to take my mind off epilame for the time being. My favourite type of dial, its a beautiful looking watch traditional English made and it runs,  the ticktock is phenomenal,  i can hear it across my living room .  You wont believe how much it was. Thats interesting about synthetic oils , i thought the same, going from a 2 year service to 5 years is a big drop in income for service folk.  I expect some did well when they embraced the use of synthetic,  probably drawing in more customers than those that didn't use the new fangled substances , i bet fairly short lived though. The more frequent service makes more sense to me, not for just the service but for the regular check up inspections that might pick up impending faults. As far as epilame goes, wouldn't it be great to be able to fumigate the complete movement in a sealed jar of heated stearic acid, 🤔 now theres a thought 😅.
    • Imm going to close the discussion by attaching the photo of my super-titanium after several vicissitudes finally working. Purchased as not working I replaced the battery and for a stroke of luck I found its semi-new solar panel which, having verified its operation, seems to recharge the accumulator perfectly. I had taken this watch almost by bet, with 40 euros I brought it back to life. The initial half idea was to resell it to finance another purchase, but.. it's definitely a nice item. It would need to check the impermeability but it's a pleasure to see it on the wrist 😃
    • In fact the secret is to go gently and find the way without forcing, and the movement enters without problems
    • Yea a have given it a full service this movement is chinese 2813 whats the lift angle for this movement does anyone knows  and how  do a remove the default  of 52 degrees on my timegrapher?   Hi you said my lift angle is default how do a remove this from my timegrapher?
×
×
  • Create New...