Jump to content

Benson Bros. Lever.

trevsunnycoast
 Share

Recommended Posts

trevsunnycoast New Member

trevsunnycoast

Posted
Posted (edited)

I have a "Benson Bros. Lever." pocket watch with a Dennison Watch Case. This seems unusual from what I have found.

My question is, in the condition it is in (see photos), is it worth or or even a candidate for repair?

Also if anyone has any idea of the age or history it would be appreciated.

Thank you.

 

Trevor

FACE.jpg

INSIDE-BACK.jpg

Edited by trevsunnycoast
forgot some commas.
Link to comment
Share on other sites
JohnD WRT Addict

JohnD

Posted
Posted (edited)

Shame about the dial damage though I suspect that an acceptable repair could be achieved with patience.....I suppose that the hands are missing because they were solid gold? If so the perpetrator appears to have missed a trick as the suspension loop seems to be hall marked and if that is true it will also be 9ct gold.....(the case itself is 'Star' quality which I believe gave a 10 year guarantee against wear.....

Edited by JohnD
Link to comment
Share on other sites
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • Neverenoughwatches
      New balance staff not riveting to balance

      By Neverenoughwatches · Posted

      You often see the term used on old watch part boxes.  Staffs for bracelet watches, timing washers for bracelet wstches etc.
    • Chief
      Intro

      By Chief · Posted

      The Boro has changed quite a lot over the last 20 years, and not for the better. I actually moved out of the town 15 years ago to a small village not far away. Thanks for the pdf! Looks a great read. I'll get it printed today and put it on my work bench!
    • Endeavor
      New balance staff not riveting to balance

      By Endeavor · Posted

      Not having all the fancy equipment, this is a way I came up with. I never said it was the best, the most ideal or the safest way. Working on balances is always a delicate task whereby full concentration & common sense should prevail. I was well aware of the "dangers" / short comings involved, hence my "warnings", as quoted above. The balance wheel of the Omega was nice true, flat and one could clearly see how much gap there was left before the grinding wheel would touch the balance wheel. I stopped when the generously applied diamond paste started to touch the rim of the balance wheel, which turned out to be with a seat thickness left of 0.1mm. Tapping the remainder of the staff out went easy and flawless. My idea of penning this article was to show/share a way which, in my case, perfectly succeeded. If deemed to risky, or if the balance wheel is not true or has a wobble, other methods have to be followed.
    • Neverenoughwatches
      Seiko 6601 Tech Sheet?

      By Neverenoughwatches · Posted

      I loved his explanation of a teardown 😅 Ex military Richard Perrett, pretty knowledgeable guy.
    • praezis
      New balance staff not riveting to balance

      By praezis · Posted

      I also see a bit of danger for the wheel, at least you have to keep away from it and may get a too thick rest ring. My rest rings are about 0.05 mm. Better way would be a grinding wheel touching the staff with its circumference. Frank
×
×
  • Create New...