Jump to content

Nacar watch movement


Ammar

Recommended Posts

Hello,

I got this watch to play with it for like 2 dollars, it's in a really terrible shape but it's ok I got it to practice on new movements, the thing is I couldn't find much information online about this particular movement it just says Swiss made 17 jewels no number nothing.

the movement isn't running at the moment but the weird thing is it runs for a couple of seconds when I pull the crown it looks in a decent condition though probably just needs to be srviced.

is there any thing that I can do for the terrible case? not that it's I want to restore it to it's original status but I just want the practice and knowledge.

I see this brand alot here I think is it Turkish? (it's pronounced Najar if it's actually Turkish)

 

 

20191116_233737.jpg

20191116_233757.jpg

20191116_233807.jpg

20191116_233819.jpg

20191116_233901.jpg

Link to comment
Share on other sites

3 minutes ago, Marc said:

That looks like an ST movement, and probably a 97-4. Do you know what the bph is?

 

Unfortunately I have no Idea what the bph is, is this TS movement any good? is it really swisss made?

Link to comment
Share on other sites

Decent  swiss made...nothing  spectacular. Made towards the end of economical swiss  mechanical  watch production. As previously  mentioned  most  likely  made by ST or standard time.very commonly  found being sold by ebay vendors from India  .search st96 watch movement. 

Edited by yankeedog
Link to comment
Share on other sites



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • Murks, The rate and amplitude look OK, and the amplitude should improve once the oils you have used get a chance to move bed-in, also I notice that you are using default 52 degrees for the lift angle, if you get the real lift angle (assuming it's not actually 52) this will change your amplitude - maybe higher, maybe lower. I notice that the beat error is a little high, but not crazy high. At the risk of upsetting the purists, if the balance has an adjustment arm I would go ahead and try and get this <0.3 ms, but if it does not have an adjustable arm then I would probably leave well alone. Just my opinion.
    • Hi everyone on my timegrapher it showing this do a make anymore adjustment someone let me know ?    
    • Maybe I'm over simplifying this and I'm a little late to the discussion, but just by my looking at oil when I use it on a treated cap jewel  the oil stays in one nice bubble, but when I don't it spreads out to the edges of the jewel. I'm not sure (but could well be wrong) but the analogy of a waxed car and rain is accurate in this case, the wax is very hydrophobic and repels the water, however, the process epilame works by is a different physical process based upon cohesion/adhesion (oleophilic) not repulsion (oleophobic)  at least as far as I have read/observed. If one were to use a oleophobic substance equivalent to wax (hydrophobic) then one would need to create a donut shape to fence in the oil, however if one used such a strategy with a epilame which is oleophilic then the oil would sit on the ring of the donut and not in the 'donut hole', exactly where you don't want it. Even if the oil is smeared then the oleophilic epilame should pull it back to the center (see diagram below). Reference For interest the chemical in epilame is 2-(PERFLUOROHEXYL) ETHYL METHACRYLATE, CAS NO: 2144-53-8
    • Looks lint the teeth on the hour wheel aren't meshing with the teeth on the calendar intermediate wheel, maybe the hour wheel is sitting on top of this instead of meshing?        
    • If the oil drop was freely standing on an epilame treated cap jewel it could easily slide off if you knocked the watch hard but the balance pivot keeps it in place. 
×
×
  • Create New...