Jump to content

Bulova 11BLAC parts


Recommended Posts

Hi

I have a Bulova 11BLAC automatic movement that I am working on. On dismantling it, I attempted to pry apart two gears attached to one of the bridges. The shaft connecting the two snapped off. The gear drives the second hand. See attached photo. I had to attempt this in order to lubricate it along with one of the jewels on the bridge. 

Is there any way of insuring this does not happen again as well as finding the parts. I have checked with Cousins but they do not have the part. I have found parts listing for the movement but doesn't provide any relevant information.

I am new to watch repairs and appreciate all the help that I have been given. 

Thanks, Terry

20180723_194032.jpg

Link to comment
Share on other sites

The unwritten rule with watch repair is don't apply force to anything. I have not worked on this movement but I presume these wheels where on posts. The way to remove is by using the correct puller as below. Or a very straight pull.

56980650_ScreenShot2018-07-24at07_51_37.png.2af6573611608a6f0c6a9619e41f15df.png

  • Like 5
  • Thanks 1
Link to comment
Share on other sites

On most watches you can just clean it in-situ and oil it from underneath the bridge if you can't slide your oiler under the wheel.

The problem is not removing the wheel, its getting it back in place as you will need to press it in from above but the pressure will mean that the wheel will pivot will also be pushing on the dial-side jewel and this is really not a good thing.

Anilv

Edited by anilv
  • Like 1
Link to comment
Share on other sites

I did one similar recently, and used the presto tool that @clockboy shows to separate the wheels, and then set up my staking set to put them back together again. No problem. If you don't have the tools,  then take @anilv's advice, and do the best job you can without taking them apart.

 

  • Like 1
Link to comment
Share on other sites

I’ve heard these movements described as the alphabet soup movements as they came with seemingly endless combinations of suffix letters. In this case you appear to be talking about parts 5b and 91 per the following: https://www.cousinsuk.com/PDF/categories/2175_Bulova 11BLA etc.pdf. These come from the base calibre 11ALC. The part which has broken is 5b, which has the swiss equivalent 214 and Cousins has this in stock... but you will bees a fine punch to press the broken staff out of the intermediate wheel. Alternatively, you may find it easier to buy a used 11ALC OR BLAC from eBay. You will need the correct tool to seperate them or if you search the web you will find alternative methods but all with the risk of damage if the wheel isn’t pulled up straight

 

 

Link to comment
Share on other sites

Thanks to everyone for your answers. Stuart, I found the 5b and 91 on the parts catalog for the Bulova 11BLAC but without the name of the wheel, I had no clue as to where to look. Where could I have found the description? Being new, I still have to learn the technical names for these watch parts. 

Link to comment
Share on other sites

21 hours ago, TerryMcCabe said:

Thanks to everyone for your answers. Stuart, I found the 5b and 91 on the parts catalog for the Bulova 11BLAC but without the name of the wheel, I had no clue as to where to look. Where could I have found the description? Being new, I still have to learn the technical names for these watch parts. 

As a new student, you should go to this web page, download all of the documents and print them out: https://www.cousinsuk.com/document/category/factory-symbols-trade-marks-ebauches-swiss-part-numbers

Once you have printed them, buy some paper index cards, copy each part number and part name onto one card per part and draw the corresponding part on the other side.

Before you go to bed every night for the next 9 months, get someone to test you on 15 to 20 parts or manufacturer symbols until you know them off by heart.

Alternatively, bookmark that page for future reference:-)

Sadly you should note that Bulova uses their own nomenclature so you have too Google their books. Mybulova.com is a good site for the older movements.

 

Link to comment
Share on other sites

  • 3 years later...
On 7/25/2018 at 10:52 PM, StuartBaker104 said:

I’ve heard these movements described as the alphabet soup movements as they came with seemingly endless combinations of suffix letters. In this case you appear to be talking about parts 5b and 91 per the following: https://www.cousinsuk.com/PDF/categories/2175_Bulova 11BLA etc.pdf. These come from the base calibre 11ALC. The part which has broken is 5b, which has the swiss equivalent 214 and Cousins has this in stock... but you will bees a fine punch to press the broken staff out of the intermediate wheel. Alternatively, you may find it easier to buy a used 11ALC OR BLAC from eBay. You will need the correct tool to seperate them or if you search the web you will find alternative methods but all with the risk of damage if the wheel isn’t pulled up straight

 

 

Hi, I came across this post and wondered how you found the equivalent number in Swiss? I can't find any reference information on this. Specifically 334,337,51 screws from 11BLA base

Link to comment
Share on other sites

That was 3 years ago… I struggle to remember what I had for breakfast this morning!

I will probably have found a Bulova interchange catalogue on the internet somewhere. Cousins has pages here which show the Swiss part number along side their own, but it’s a bit slow going as the pages are indexed by the Swiss number

https://www.cousinsuk.com/document/category/bulova-movement-parts

 

Link to comment
Share on other sites

14 hours ago, StuartBaker104 said:

That was 3 years ago… I struggle to remember what I had for breakfast this morning!

I will probably have found a Bulova interchange catalogue on the internet somewhere. Cousins has pages here which show the Swiss part number along side their own, but it’s a bit slow going as the pages are indexed by the Swiss number

https://www.cousinsuk.com/document/category/bulova-movement-parts

 

Ha Ha I know the feeling, It was just a hope. I use Cousins often but running thought the paperwork I can't find a Swiss part next to the part in question. Thank you for letting me know though.

Link to comment
Share on other sites

13 hours ago, Nucejoe said:

 Have you checked with speedtimekolektion? 

There is a good chance they have the part, shiw them picture.

Ships free in europe.

I did have a look through them too but always worth giving it another try, Thank you.

Link to comment
Share on other sites



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • does anyone knows what type of battery this digital Watch takes?  
    • Hello good watch folk ,I  just fancied a light hearted discussion after my head was starting to spin over Epilame 😅. Specifically I'm meaning the sale of vintage watches, say nothing past the 1980s market. The stuff we see on ebay and other similar sites and found at carboots, curio shops etc. And are  we thinking its reaching a peak volume ?  Younger generations clearing out passed parents and grandparents possessions.  The younger folk are not as sentimental as the old fogies ( I'm now nearly at an age that i used to think was old fogie age ). When might it have started ?  i often wish i discovered the hobby much much sooner when selling your grandfathers pocket watch at a boot sale for a few quid was just a way to offload some tat. And when might it slow down. Thoughts anyone ?
    • Yes i did eventually realise that the oil will act as a barrier, I'm sure the discussion will continue. Ive had two oleophobic coffees ( added coconut ) and in the meantime i have this just delivered to take my mind off epilame for the time being. My favourite type of dial, its a beautiful looking watch traditional English made and it runs,  the ticktock is phenomenal,  i can hear it across my living room .  You wont believe how much it was. Thats interesting about synthetic oils , i thought the same, going from a 2 year service to 5 years is a big drop in income for service folk.  I expect some did well when they embraced the use of synthetic,  probably drawing in more customers than those that didn't use the new fangled substances , i bet fairly short lived though. The more frequent service makes more sense to me, not for just the service but for the regular check up inspections that might pick up impending faults. As far as epilame goes, wouldn't it be great to be able to fumigate the complete movement in a sealed jar of heated stearic acid, 🤔 now theres a thought 😅.
    • Imm going to close the discussion by attaching the photo of my super-titanium after several vicissitudes finally working. Purchased as not working I replaced the battery and for a stroke of luck I found its semi-new solar panel which, having verified its operation, seems to recharge the accumulator perfectly. I had taken this watch almost by bet, with 40 euros I brought it back to life. The initial half idea was to resell it to finance another purchase, but.. it's definitely a nice item. It would need to check the impermeability but it's a pleasure to see it on the wrist 😃
    • In fact the secret is to go gently and find the way without forcing, and the movement enters without problems
×
×
  • Create New...