Jump to content

New member introduction

Ashy

By Ashy
in Introduce Yourself Here

 Share

Recommended Posts

Ashy New Member

Ashy

Posted
Posted

Hello Fellow Members,

I have always been interested in watch/clock repair after discovering the existence of mechanical/automatic watches.

I have recently inherited a Swiza 8 Genie alarm clock which I am trying to fix. I also have a knock-off Datejust which could fair good watch repair practice as well.

I am sure I will be requiring a lot of help on my journey to fix the clock from you all. I hope I can be of some value to this forum.

Thanks,

Ashy

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • Mercurial
      Smit

      By Mercurial · Posted

      We need to identify the movement to help you, but the oldest of these Rolco watches use Aegler-Rebberg movements that lack a calibre number and are very difficult to identify. You may end up having to make or modify a stem to fit . Post pictures of both sides of the movement when you have it and the size of the movement and hopefully it’s one that has a calibre number.  Gruen used a lot of the same Aegler movements at the time and it’s worth comparing your movement with those if you can’t find it labeled as an Aegler or Rolex/Rolco calibre. Best Regards, Mark  
    • Neverenoughwatches
      Winding pinion making

      By Neverenoughwatches · Posted

      Onlly a pro's eye would notice that OH, you've still got it old fella 🙂
    • Mercurial
      How to remove shock settings from Smiths 512 movement

      By Mercurial · Posted

      The triple lobed spring, as you suggest needs to be rotated to remove it or replace it. Suitably shaped pegwood should suffice, but tools (shaped as you describe) for the purpose also exist.  If you have an assorted of replacement springs, a trilobe style KIF spring of the right size might fit.  The other spring securing the jewel also needs rotating. There is a slight opening in the setting at about the 5 o’clock position in your photo and one side of the spring should be able to be removed  there when rotated into position.  Hope that helps, Mark
    • RobS
      How to remove shock settings from Smiths 512 movement

      By RobS · Posted

      As an update, it transpired the setting on the balance side, with the jewel had one flat end and one curved. When I rotated it enough it popped out. The chaton was entirely conical and a tricky customer but once lubricated and dropped back in I put the flat edge in first and poked it in with the peg wood tool mentioned above (I made it with flattening off the end then sizing with a pencil sharpener before poking a hole in the end) then rotated and it went in well.    For the other side, magnet searching for the spring has been fruitless.    thanks for the link to the other thread
    • Rustinbox
      Omega Split stem issue (will not go back in)

      By Rustinbox · Posted

      Thank you. It didn’t look rusty. For sure old.    Female part was inside the movement, and when I pushed male part, it got broken. I didn’t apply grease. Here is the photo.      Could it be that male part is too thick for some reason?
×
×
  • Create New...