Juvenia 604

[Mehran]

Hello to everyone,

I am trying to service a Juvenia 604 mechanical movement watch.

The difficulty that I have is removing the movement from the case.

It seems to be stuck there.

Any suggestions?

 

thanks,

[oldhippy]

Thank you for your introduction and welcome to this friendly forum.

Some cases can be buggers if you are not familiar with all the different types. Photos of the front/back and a side view will help members to help you. 

[Nucejoe]

Welcome to the forum Mehran.

[Mehran]

Thanks!

hopefully this picture can help.

I removed the stem and two other screws on the sides, but the movement does not budge.

 

[Mehran]

Should I pry it open?

[oldhippy]

No photo of the front. Can you remove the glass and see if you can push the movement out that way. 

[Mehran]

Oh yes,

Here you go!

[oldhippy]

Looks like the bezel should come off with a good case knife. Then the movement will drop out. If you can't get it off with your knife a razor blade will do it. 

[Mehran]

Didn't think about that!

Cheers,

Will check it out.

 

[watchweasol]

Hi  Yes Old Hippy is right it looks like a front loader, dial is bigger than the movement.  Be careful with the blade.

[watchweasol]

Hi   for a comprehensive spec sheet the following link will suffice

http://www.ranfft.de/cgi-bin/bidfun-db.cgi?12&ranfft&0&2uswk&Juvenia_604                          cheers

 

 

[Mehran]

Hi,

Wanted to thank you for your helpful info.

The watch is taken apart and already cleaned the bezel.

Attached are pictures of the dial itself.

Rodico did not help. It looks rusted, not sure.

Any ideas?

 

Cheers

[oldhippy]

As its an old movement you could try a watch suppliers and give them the cal number and see if they have dials to fit the cal. Watch dials are very expensive to have restored. You could put the word out on here giving the cal number and see if you get a reply. 

[Michael1962]

Welcome to the forum Mehran.

Lots of helpful people on here.