Jump to content

Searching for a Seiko Crystal


Recommended Posts

As often asked and answered. There is no secret place for parts. The searches you can do are the same that all others here do - Internet, Ebay, well-know online material houses.

  • Like 1
Link to comment
Share on other sites

18 hours ago, Dave84 said:

I ended up finding one on ebay for £38 including postage

Congrats! Objectively it's still a lot of money for a crystal (you can get a great mechanical Russian watch for that money), but for a watch that means a lot to you, £38 can still feel like a bargain.

Edited by VWatchie
  • Like 1
Link to comment
Share on other sites

you dont always need an original,  measure the old one, I can see from the part number its 30mm and probably is a tension ring too so you can get a generic one for less than £10.00 that will do the same job. 

I have done this one many plain Seiko crystals even glass ones. 

Link to comment
Share on other sites

1 hour ago, MyRetroWatches said:

you dont always need an original,  measure the old one, I can see from the part number its 30mm and probably is a tension ring too so you can get a generic one for less than £10.00 that will do the same job. 

Are you sure? Picture from the Ebay listing of someone asking $78 (!!) for it.

s-l500.jpg

With it's large bezel and domed shape is not a good candidate for generic replacement. And it happens, beginners and amateurs aren't able to swap a bezel or tension ring from a crystal to another.

And here's how anyone can decode (up to an extent) Seiko crystal codes Crystal Codes.pdf

Edited by jdm
Link to comment
Share on other sites

  • 3 weeks later...

Hi Guys, just a quick update, again thanks for the responses. 

Just wanted to add a quick pic of the new crystal which came fixed within a retaining ring which sat beneath the bezel ring.

Cheers

Dave 

IMG_20200806_140836_BURST001_COVER.jpg

  • Like 1
Link to comment
Share on other sites



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • How about using a magnetised screwdriver for picking-up and fitting screw, then run the assembly through a demagnetiser.  I know magnetism is a no no, but this method is less fiddly, and has worked for me on several occasions.
    • Find a plastic tube, cut longer than the K&D, put your tools etc in it and hold both ends.  The plastic shouldn't have any effect. 
    • Hi, I’m thinking about upgrading my demagnetizer and wanted to check to see if anyone has experience (good or bad) with the Chinese knockoff of the Elma demagnatizer. At present I use the cheap blue job on watch movements and while a tad clunky it seems to work OK for movements. However it doesn’t really handle tools and other larger pieces (like my anvils which are very magnetized) particularly well. i also have a US made K&D demag unit but have put it aside permanently re: it is so strong I can’t hold the tools, anvil whatever stable enough while passing the piece through the donut hole and ultimately the piece ends up more magnetized then when I started. Feedback would be most welcome since I can’t justify the $299 for a Elma unit but can spring $49 for a Chinese knock off.   thanks jay   
    • Hi there, welcome  
    • Due to inflation our 404 club price cap seems a little unworkable, so here are some options to re-boot ihe idea - first three are what common currency to choose (pic 1  out of 3) the rest 4-10 are the price cap  (pick 1 out of the 7 options)
×
×
  • Create New...