Jump to content

Tissot t670 help

caz884
 Share

Recommended Posts

caz884 New Member

caz884

Posted
Posted

I need help. My partner has a tissot t670 which belonged to his father before he died. I tried to be helpful and change the battery when it stopped, but I've lost the back cover. I think it may have been thrown out. I've looking all over for a replacement does anybody know where I can get one?

Link to comment
Share on other sites
jdm Distinguished Member

jdm

Posted
Posted (edited)

An original part is not easy or just impossible to obtain, your best option  is to contact the official service center and inquire about availability. If it is they will most likely demand that the watch is sent to them.

Edited by jdm
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • Michael1962
      Vertex Dirty Dozen crystal

      By Michael1962 · Posted

      Certainly looks like a ring that needs unscrewing in that photo. It definitely looks like a thread above the castellated ring as well. Separate to the caseback ring thread. It even looks to be a smaller diameter. I would expect that. Once undone out of its thread, it should fall out of the case. Would it be possible to make a tool shaped like a letter H with one side of the H engaging the castellations in the ring and the other side of the H for you to be able to unscrew it using your hand? Making a tool with 6 'legs' to pick up all of the castellations would be a labour of love.
    • B1N9S
      Vertex Dirty Dozen crystal

      By B1N9S · Posted

      Can anyone advise how to remove the crystal from a Vertex DD case ?  I think I need to unscrew an internal retainer ?  It definitely isn't just pushing out.
    • SamLiddle
      Help for a novice - fused spring bar

      By SamLiddle · Posted

      Alright, the job is done. I first filed down the stubs flat. I then used a Proxxon hand drill first with a 0.5mm bit to score a point to work from, then a 1mm drill bit to properly drill out some lug holes. I just went slowly, checking the depth as I went. I drilled the inside of the lugs, leaving the outsides unblemished. I was worried that drilling at an angle might be a problem, but it turned out fine. Lug holes don't need to be very accurate, so it was actually easy to create holes to easily accommodate a spring bar. The result is a 'good enough' outcome that worked for me. Thanks for your help everyone, loving the hobby so far. I learn so much with each project.
    • watchweasol
      Hello from Wales, UK.

      By watchweasol · Posted

      Welcome to the forum. Yep not a cheap hobby by any means , Ali Express, the Chinese Amazon has some decent tools but should ask the members their thoughts before purchase.  A little reading to help you along. TZIllustratedGlossary.pdf
    • clockboy
      Hello from Wales, UK.

      By clockboy · Posted

      Welcome to the forum, enjoy.
×
×
  • Create New...