Jump to content

Pressing flat mineral glass with Robur press.

Flubber

By Flubber
in Tools & Equipment

 Share

Recommended Posts

Flubber Watch Enthusiast

Flubber

Posted
Posted

Hello,

 

I have ordered a robur glass press and dies (expensive) and my first project is to change the mineral glass of my nephew's watch. However, when I watched Mark's videos on changing glass he used a flat die but as far as I can tell there are no flat dies in the robur die set. My question is if I can still use the press with the supplied dies or use some sort of plate between the die and the glass without breaking anything, neither the watch nor the die ?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • Chief
      Intro

      By Chief · Posted

      The Boro has changed quite a lot over the last 20 years, and not for the better. I actually moved out of the town 15 years ago to a small village not far away. Thanks for the pdf! Looks a great read. I'll get it printed today and put it on my work bench!
    • Endeavor
      New balance staff not riveting to balance

      By Endeavor · Posted

      Not having all the fancy equipment, this is a way I came up with. I never said it was the best, the most ideal or the safest way. Working on balances is always a delicate task and full concentration & common sense should prevail. I was well aware of the "dangers" / short comings involved, hence my "warnings", as quoted above. The balance wheel of the Omega was nice true, flat and one could clearly see how much gap there was left before the grinding wheel would touch the balance wheel. My idea of penning this article was to show/share a way which, in my case, perfectly succeeded. If deemed to risky, or if the balance wheel is not true or has a wobble, other methods have to be followed.
    • Neverenoughwatches
      Seiko 6601 Tech Sheet?

      By Neverenoughwatches · Posted

      I loved his explanation of a teardown 😅 Ex military Richard Perrett, pretty knowledgeable guy.
    • praezis
      New balance staff not riveting to balance

      By praezis · Posted

      I also see a bit of danger for the wheel, at least you have to keep away from it and may get a too thick rest ring. My rest rings are about 0.05 mm. Better way would be a grinding wheel touching the staff with its circumference. Frank
    • Neverenoughwatches
      Stem broken - can it be rescued?

      By Neverenoughwatches · Posted

      Not easy to find this one everywhere,  so it depends where you are located. Joining it back together might be possible, i have silver soldered mild steel before even with traditional plumbers lead and its a pretty strong joint, but bere in mind this is only 1mm diameter.  The join would need to be very accurate,  it not something i have heard of anyone trying before. The part no 401 is the swiss code number and relates to watch winding stems in general
×
×
  • Create New...