Jump to content

Watch winder: do or don't


Recommended Posts

Hi, is there something sensible to say about the use of a watch winder? Does it keep your  automatic watch in good health (oil-wise and 'use it or lose it' principle) or is it bad for the movement (main spring wound 24/7) and causing excessive wear to the moving parts. Keep hearing all sorts, I hope to find a clear answer.

Thanks for helping out!

Link to comment
Share on other sites

I don't think I've ever heard a plausible explanation of why a watch winder would put more wear and tear on a watch than simply wearing it. I also don't think I've ever heard a plausible explanation of how exercising a watch would keep it "healthy".  Exercise for me, yes. A mechanical watch is going to need service whether it's been worn every day, or it's been sitting on a watch winder, or in a drawer.  Oils degrade, some more slowly than others, and it's amazing how over time dirt will get into a supposedly sealed watch. 

A properly maintained quality mechanical watch can last a very, very, long time, it can be an heirloom.  But it is the care taken with the watch when it's out and about in the world, and the regular maintenance given to it that makes this possible. The fact that it may have spent time on a watch winder is going to get lost in the noise :-)

Have Fun!

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • Thanks everyone for your helpful replies. I think between us we’ve worked out what’s going on. Next job is to have a proper look at this great wheel assembly, see if I can remove the clip and the friction fit pinion, give the bits a good clean, then put it back together with a bit of blue grease. I’ll also get the pallet fork under the microscope to see if it’s ok or been damaged. 
    • The cannon pinion (be it conventional style or what you see in this movement) should slip on its arbour so the hands can be set independently without affecting the gear train.  If there is too much friction between the cannon pinion and the second wheel, turning the hands to set them backwards can sometimes force the escape wheel teeth to overrun the pallet stones, creating the behaviour you describe. The train is running in reverse when this happens.  This can often chip the pallet stones. I’d say at least half of the watches I’ve inspected with very tight cannon pinions had chipped pallet stones. Hopefully this isn’t the case with your watch.  I’m not familiar with this movement but you need to get the friction in the cannon pinion adjusted correctly.  Hope this helps, Mark
    • Pallet fork was in. I’d had the movement running ok, and only removed the balance to flip it over and install the keyless works and date mechanism. The pallet fork wasn’t locking the gear train when hand setting - it was oscillating as the escape wheel rotated. This may have been in one direction only - can’t remember. 
    • Hi   Find attached parts/repair notes for the JLC 911,  might be useful. JLC_JLC 910, 911.pdf JLC_JLC 910, 911 Repair Notes.pdf
    • Hello and welcome to the forum Dan. Used to know Middlesboro quite well, that was twenty years plus ago. Attached a little reading to get you started. TZIllustratedGlossary.pdf
×
×
  • Create New...