Jump to content

Guess the X-Ray :-)


Recommended Posts

Hey folks!

I was in the radiology department when the X-Ray machine needed to make some test-scans for routine calibration. The technician jokingly asked if I had something I wanted an X-Ray of ... so naturally I handed him my watch. Can you guess the watch I wore by the scan?

IMG_8990.jpeg

Link to comment
Share on other sites

On 2/9/2024 at 8:19 AM, CHRGDR said:

X-Ray machine

In addition to x-rays does the machine have a byproduct of magnetic fields? Yes I know a better test for your watch would be with the MRI machine but what sort of magnetic fields does the x-ray machine produce and did it affect the timekeeping of the watch?

Link to comment
Share on other sites

On 2/11/2024 at 11:59 AM, JohnR725 said:

In addition to x-rays does the machine have a byproduct of magnetic fields? Yes I know a better test for your watch would be with the MRI machine but what sort of magnetic fields does the x-ray machine produce and did it affect the timekeeping of the watch?

As far as I know an x-ray machine does not produce a significant magnetic field nor is it influenced by one. I am no expert on this matter however, so I might be wrong. I have not noticed any negative effects on timekeeping yet. I probably would not have done this with any of my older, more delicate watches though.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • Hi and welcome. First of all, check the power reserve. If the watch is runing, this means the spring is attached to the barrel arbor. If there is no end of winding, this probably means that the spring is not attached to the barreland it's outer end is slipping. In such case, the watch will run, but the power reserve will be small - about several hours
    • Hi welcome to the forum. One can only reiterate the diagnosis already made by clockboy mainspring problem. But before tearing it to pieces take a little time to read the attached file to acquaint yourself with all the various parts. TZIllustratedGlossary.pdf
    • We think about these preps as "one-dips" partly because they are terrific solvents but also because the parts they are used on are often cleaner in general than many other parts. But old oils petrify, and even something like B-Dip can't clean up over-soiled parts without some extra effort, as mentioned above. There is an intermediate step during cleaning where the solvent can partially dissolve tarry residues so they have a more liquid varnish-like consistency, and that could well be what you are seeing on the coils after two washes. I wouldn't worry that your B-Dip was contaminated before you used it on this hairspring, but it I wouldn't re-use that aliquot AFTER this cleaning!
    • Welcome to the forum, enjoy.. Normally if a hand wound watch does not fully wind ie just keeps winding there is an error with mainspring, either slipping around its winding arbour or the mainspring is broken. 
    • Most all my 404 candidates are coming from swap meets and "antiques fairs". One more $4US plus battery and elbow grease. Unnamed digital on a decent ss bracelet. Gains 10 seconds a day so not that accurate...
×
×
  • Create New...