-
Recently Browsing
- No registered users viewing this page.
-
Topics
-
Posts
-
After a good soak in IPA and tickle with an artist’s brush and then another dip in Lubetta the reversing wheels are back in the watch and working a lot better!
-
So there are a few variants of the Horia clone. That’s why I’d like to know the dimensions of the Bergeon 31001 - I need a version that will accept whatever the dimensions of the Bergeon pieces are. I’ll email Cousins on Monday and ask them, unless Malocchio is able to measure his set for me. Then I’ll search for a clone to fit. @Waggy _ I can well imagine it takes some practice. Likely I’ll wreck a few along the way. I’ll push a smoothing broach along the pipe and see if that limits the damage.
-
By Neverenoughwatches · Posted
Apparently there are versions of the horia clone that are 3mm and 4mm, for some unknown reason i thought it was the stumps that varied and not the pushers but i may be wrong here. The clone i have both the pushers and stumps are 4mm and accept Seitz 4mm pushers and Star 4mm staking stumps and all the clone stumps fit the seitz and Star bases. I take it you are sliding a restriction pin in the cp Scott. -
Hi mikepilk and JohnR725, Thanks for the the reply and advice. Though i don't have good experience in watch repairs except couple of Seikos i.e. 7009a & 6309 Repairs, but i am good at diagnosing and understanding the workings. I know the watch has been rusted badly, but if you get it for as cheap as $90 , where in good condition the cost is $1500. But i Promise you guys i will repair it and will share the picture when it be running soon. Regards. Usman
-
Recommended Posts