Jump to content

ESA 9183 question....

Watchtime
 Share

Recommended Posts

Watchtime Super WRT Addict

Watchtime

Posted
Posted (edited)

Got this nice vintage quartz Belinda at a yard sale. I need to replace the crystal and the crown.

Anyone knows how to release the stem?

I gently pushed the little thing on the right of the arrow as it moves when pulling out the crown but it doesn't release the stem. I also turned the screw just above the stem about 1/2 a turn...no release.

Thanks.esa9183w.jpg.94cb275f3f9e6ebcac68609648ac2b07.jpg

Edited by Watchtime
Link to comment
Share on other sites
Marc Distinguished Member

Marc

Posted
Posted

I did one of these last year, details here.

As far as I can remember the post that you have arrowed is the correct part to push. I can't remember if the stem has to be in the setting position or not but just try it either way.

Link to comment
Share on other sites
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • RichardHarris123
      Without Our Forum

      By RichardHarris123 · Posted

      I'm bothered but I agree he's a busy man and I don't want to bother him.  In the meantime, we really do need to have other ways of contacting each other  
    • RichardHarris123
      Second hand watch market.

      By RichardHarris123 · Posted

      This is as complicated as epilame, too many unknowns. The life expectancy in the UK is circa 80, so most people from 1944 or earlier are dead.  Assume they had children at circa 20, they died in 2004. Their children started selling 1944 watches in 2004, so pre-1944 watches must be getting more rare.   It doesn't work though because as you stated some were sold as tat, but since watch prices have increased people have decided to sell when they may not of done in the past. 
    • Michael20
      Questions about my Bravingtons Renown Mantel Clock

      By Michael20 · Posted

      I was wondering whether anyone could assist with some questions I have about my latest acquisition, which is a two train ‘Bravingtons Renown’ mantel clock - Pics attached I have done some reading about Bravingtons and believe they sourced movements from various suppliers, so I wondered whether anyone recognises this one. I have stripped and cleaned the movement and the clock is now running well, but there are a couple of dodgy brass springs that I would like to replace. I haven’t found anything suitable searching the internet so I wondered does anyone know of a supplier that might help. Last question is about the veneer on the case, it is generally in reasonable condition but there are a couple of patches on the top where the veneer has lifted. So far, I have tried to reactivate the existing adhesive by heating from below and above with a hair drier, then clamping for a day or two. It has improved slightly but the bulge is still visible. I’d be grateful for any advice if anyone has dealt with this sort of repair before.
    • watchweasol
      Insert the movement inside the case

      By watchweasol · Posted

      Hi some pictures o& the movement and case would be appreciated so we can ascertain what the problem is you are having in fitting the movement.   Thank you.
    • dnhb
      First pendulum clock tinker

      By dnhb · Posted

      Thank you very much,T. I'll try turning the arbour from the clock face end very carefully in case I haven't reassembled the suspension block correctly (I had to make up a suspension spring using remnants of a broken one as I haven't been able to find an exact replacement online).
×
×
  • Create New...