Jump to content

Hanging in the balance.

SparkyLB

By SparkyLB
in Watch Repairs Help & Advice

 Share

Recommended Posts

watchweasol Distinguished Member

watchweasol

Posted
Posted

Hi    The short answer is NO as the prolonged weight of the wheel will have an adverse effect on the spring, It was not intended to hang for long periods. If the balance is to be left out of the watch with its cock turn the whole thing upside down and rest the balance in the jewel and cover for protection. If removed from the cock place on an old balance complete carrier an again remove out of harms way. A little for thought can save a lot of money not to mention time.

  • Like 3
Link to comment
Share on other sites
yankeedog Distinguished Member

yankeedog

Posted
Posted

I have found that there are hairsprings that don't take well to hanging AT ALL !I have ruined Lorsa hairsprings by just letting them dangle long enough to install the balance cock.I wouldn't let one hang any longer than ABSOLUTELY NECESSARY.

  • Like 3
Link to comment
Share on other sites
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • RichardHarris123
      Omega cal. 565 - low amplitude

      By RichardHarris123 · Posted

      @JohnR725 has pointed out many times that the Swiss don't care about amplitude, the timekeeping is the most important.  Give yourself a  pat on the back, great beat error and timekeeping, nothing to be disappointed about. 
    • RichardHarris123
      Without Our Forum

      By RichardHarris123 · Posted

      I'm bothered but I agree he's a busy man and I don't want to bother him.  In the meantime, we really do need to have other ways of contacting each other  
    • RichardHarris123
      Second hand watch market.

      By RichardHarris123 · Posted

      This is as complicated as epilame, too many unknowns. The life expectancy in the UK is circa 80, so most people from 1944 or earlier are dead.  Assume they had children at circa 20, they died in 2004. Their children started selling 1944 watches in 2004, so pre-1944 watches must be getting more rare.   It doesn't work though because as you stated some were sold as tat, but since watch prices have increased people have decided to sell when they may not of done in the past. 
    • Michael20
      Questions about my Bravingtons Renown Mantel Clock

      By Michael20 · Posted

      I was wondering whether anyone could assist with some questions I have about my latest acquisition, which is a two train ‘Bravingtons Renown’ mantel clock - Pics attached I have done some reading about Bravingtons and believe they sourced movements from various suppliers, so I wondered whether anyone recognises this one. I have stripped and cleaned the movement and the clock is now running well, but there are a couple of dodgy brass springs that I would like to replace. I haven’t found anything suitable searching the internet so I wondered does anyone know of a supplier that might help. Last question is about the veneer on the case, it is generally in reasonable condition but there are a couple of patches on the top where the veneer has lifted. So far, I have tried to reactivate the existing adhesive by heating from below and above with a hair drier, then clamping for a day or two. It has improved slightly but the bulge is still visible. I’d be grateful for any advice if anyone has dealt with this sort of repair before.
    • watchweasol
      Insert the movement inside the case

      By watchweasol · Posted

      Hi some pictures o& the movement and case would be appreciated so we can ascertain what the problem is you are having in fitting the movement.   Thank you.
×
×
  • Create New...