Jump to content

Problem with Pocket watch

jdrichard

By jdrichard
in Watch Repairs Help & Advice

 Share

Recommended Posts

jdrichard Distinguished Member

jdrichard

Posted
  • Author
Posted

Found the problem . The leaf spring was not pressing the hour gear down as it was not there. So when you turned the watch around the hour gear would fall slightly and the gear touching the hour gear would jam. I managed to find a leaf spring and adjusted the hole size so it fit over the gear. Now the watch works well in all positions. So it was a kind in end shake:)

Thanks all.


Sent from my iPhone using Tapatalk Pro

  • Like 1
Link to comment
Share on other sites
 Share
Go to topic listing


  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • Michael20
      Questions about my Bravingtons Renown Mantel Clock

      By Michael20 · Posted

      I was wondering whether anyone could assist with some questions I have about my latest acquisition, which is a two train ‘Bravingtons Renown’ mantel clock - Pics attached I have done some reading about Bravingtons and believe they sourced movements from various suppliers, so I wondered whether anyone recognises this one. I have stripped and cleaned the movement and the clock is now running well, but there are a couple of dodgy brass springs that I would like to replace. I haven’t found anything suitable searching the internet so I wondered does anyone know of a supplier that might help. Last question is about the veneer on the case, it is generally in reasonable condition but there are a couple of patches on the top where the veneer has lifted. So far, I have tried to reactivate the existing adhesive by heating from below and above with a hair drier, then clamping for a day or two. It has improved slightly but the bulge is still visible. I’d be grateful for any advice if anyone has dealt with this sort of repair before.
    • watchweasol
      Insert the movement inside the case

      By watchweasol · Posted

      Hi some pictures o& the movement and case would be appreciated so we can ascertain what the problem is you are having in fitting the movement.   Thank you.
    • dnhb
      First pendulum clock tinker

      By dnhb · Posted

      Thank you very much,T. I'll try turning the arbour from the clock face end very carefully in case I haven't reassembled the suspension block correctly (I had to make up a suspension spring using remnants of a broken one as I haven't been able to find an exact replacement online).
    • watchweasol
      Digital Watch

      By watchweasol · Posted

      Hi murks a picture of the front as well would help,   By the size of the plate it was stuck to I would suggest a coin cell,  2030,  2015 all depends on the height of the cell. And the space when the back is fitted.         3 volt. 
    • Neverenoughwatches
      Without Our Forum

      By Neverenoughwatches · Posted

      We seem to have gone a bit quiet on this ?  Do we all agree to ask Mark for some input on this matter, or is no-one really bothered. 
×
×
  • Create New...